1. Home
    2. /
  2. Manuals
    3. /
  3. D-Link
    4. /
  4. DIR-412
    5. /
  5. 6
Page 26 / 101 Scroll up to view Page 21 - 25
22
D-Link DIR-412 User Manual
Section 3 - Configuration
If you selected L2TP, enter your L2TP username
and password. Click
Next
to continue.
If you selected Static IP Address Connection, enter
the network settings supplied by your Internet
provider. Click
Next
to continue.
Page 27 / 101
23
D-Link DIR-412 User Manual
Section 3 - Configuration
Russia PPTP (dual mode)
and
Russia PPPoE
(dual mode)
are specifically for Russian users.
Please fill in the username and password given by
Russia ISPs and click
Next
to continue.
Other users may ignore these 2 settings.
Page 28 / 101
24
D-Link DIR-412 User Manual
Section 3 - Configuration
Click
Connect
to save your settings and reboot
the
router. Please allow 1-2 minutes to connect.
If you left the
Skip 3G Configuration
checkbox
unchecked in
Step 3
of the
Internet Connection
Setup Wizard
, the following window appears:
Configure the parameters for your 3G Internet
Connection and click next to
Continue
.
Page 29 / 101
25
D-Link DIR-412 User Manual
Section 3 - Configuration
If you opt to set up your Internet connection manually, you will be redirected to a WAN page that allows you to select
your Internet type and enter the correct configuration parameters.
Manual Configuration (WAN Mode)
Select your Internet connection type using
the “
My Internet Connection is:
” drop-down
menu. To enable the Router to connect to the
Internet via the 3G Internet connection in the
event that the WAN connection fails, check
the
Enable WAN Failover
box. Configure the
parameters for your WAN connection in the
section below the
Internet Connection Type
section as described in the following pages.
If enabling the WAN Failover feature,
configure the parameters for your 3G Internet
Connection.
Internet
Connection
Type:
3G Internet
Connection:
Click the
Save Settings
button when you have
finished configuring the WAN connection.
Page 30 / 101
26
D-Link DIR-412 User Manual
Section 3 - Configuration
Enter the IP address assigned by your ISP.
Enter the Subnet Mask assigned by your ISP.
Enter the Gateway assigned by your ISP.
Enter the Primary and Secondary DNS server
IP addresses assigned by your ISP.
Maximum Transmission Unit - You may need to
change the MTU for optimal performance with
your specific ISP. 1500 is the default MTU.
The default MAC Address is set to the Internet
port’s physical interface MAC address on the
Broadband Router. It is not recommended that
you change the default MAC address unless
required by your ISP. You can use the
Clone
Your PC’s MAC Address
button to replace
the Internet port’s MAC address with the MAC
address of your Ethernet card.
IP Address:
Subnet Mask:
Default Gateway:
DNS Servers:
MTU:
MAC Address:
Choose
Static IP (DHCP)
from the
My Internet Connection is
drop-down menu if all the Internet port’s IP information
is provided to you by your ISP. You will need to enter in the IP address, subnet mask, gateway address, and DNS
address(es) provided to you by your ISP. Each IP address entered in the fields must be in the appropriate IP form,
which are four octets separated by a dot (x.x.x.x). The Router will not accept the IP address if it is not in this format.
Manual Configuration (WAN Mode)
Manual Configuration (WAN Mode)
Static IP Address

Rate

4 / 5 based on 1 vote.

Popular D-Link Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top