Page 71 / 114
Scroll up to view Page 66 - 70
66
D-Link DIR-330 User Manual
Section 4 - Security
Wireless Security Setup Wizard
To run the security wizard, click on
Setup
at the top and then
click
Launch Wireless Security Setup Wizard
.
Click
Next
to continue.
Page 72 / 114
67
D-Link DIR-330 User Manual
Section 4 - Security
Enter the SSID (Service Set Identifier). The SSID is the
name of your wireless network. Create a name using up to
32 characters. The SSID is case-sensitive.
Click
Next
to continue.
Select the level of security for your wireless network:
•
Best
– WPA2 Authentication
•
Better
– WPA Authentication
•
Good
– WEP 128-bit Authentication
•
None
– No Security
Click
Next
to continue.
If you selected Best or Better, enter a password between
8-63 characters.
Click
Next
to continue.
Page 73 / 114
68
D-Link DIR-330 User Manual
Section 4 - Security
If you did not enable encryption, the following screen will
appear.
Click
Save
to finish the Security Wizard.
If you selected Good, enter a WEP encryption key (13
characters or 26 Hex (A-F, 0-9) characters).
Click
Next
to continue.
If you selected Best, the following screen will show you your
Pre-Shared Key to enter on your wireless clients.
Click
Save
to finish the Security Wizard.
Page 74 / 114
69
D-Link DIR-330 User Manual
Section 4 - Security
If you selected Good, the following screen will show you your
WEP Key to enter on your wireless clients.
Click
Save
to finish the Security Wizard.
If you selected Better, the following screen will show you your
Pre-Shared Key to enter on your wireless clients.
Click
Save
to finish the Security Wizard.
Page 75 / 114
70
D-Link DIR-330 User Manual
Section 4 - Security
Configure WEP
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1.
Log into the web-based configuration by opening a
web browser and entering the IP address of the router
(192.168.0.1). Click on
Setup
and then click
Wireless
Settings
on the left side.
2. Click the
Manual Wireless Connection Setup
button.
3. Next to Security Mode, select
Enable
WEP
.
4. Next to Authentication, select
Shared Key
or
Open
.
5. Next to WEP Encryption, select the level of ecryption (64
or 128-bit).
6. Next to Default WEP Key, select the key to modify. You
may enter up to 4 different keys.
7. Next to WEP Key, enter a WEP key you create. Make
sure you enter this key exactly on all your wireless
devices.
8. Click
Save Settings
to save your settings. If you are configuring the router with a wireless adapter, you will lose
connectivity until you enable WEP on your adapter and enter the same WEP key as you did on the router.
19216811.live