Page 16 / 149
Scroll up to view Page 11 - 15
1³
D-Link DCS-34±0 User Manual
Section ± - Installation
To access the Installation Wizard screen, click on the Installation Wizard Icon on your desktop.
The opening Installation Wizard screen will appear and show a MAC address of the DCS-3420 and an IP Address. If
you have a DHCP* server on your network, there will be a valid IP Address displayed here, indicated by a “Yes” under
the assigned column.
*A DHCP server is a device that supplies IP Addresses to its clients that are on the same network.
Page 17 / 149
1´
D-Link DCS-34±0 User Manual
Section 3 - Configuration
Installation Wizard
The following options are available on the Installation Wizard screen by clicking on the corresponding tab:
Configuration
This section will show you how to configure your new D-Link wireless internet camera using the D-Link Installation
Wizard.
Click
Setup
Page 18 / 149
18
D-Link DCS-34±0 User Manual
Section 3 - Configuration
On the initial Setup Screen you can configure System and Date/Time settings for each camera. Click
Next
to
configure Network settings for the camera.
Click
Next
Setup
Page 19 / 149
1µ
D-Link DCS-34±0 User Manual
Section 3 - Configuration
Users can configure the Network Settings for the camera
by entering the IP address, Subnet mask, Default router IP,
Primary DNS, and Secondary DNS. The option to
reset IP
address at next boot
is automatically selected. If you would
like to keep your IP address settings, make sure to uncheck
this box.
Click
Next
Network Settings
Page 20 / 149
±0
D-Link DCS-34±0 User Manual
Section 3 - Configuration
Users can configure the Wireless Network Settings for
the camera, by entering the SSID and selecting the
Wireless Mode, Channel, TX Rate, and Preamble.
Note:
Check the Data Encryption box to enable data
encryption and configure the settings.
These settings are
explained and can also be configured on the
Advanced >
Network
screen (page 33) when configuring the camera
via a Web Browser.
Click
Next
Wireless Network Settings
19216811.live