Page 71 / 83
Scroll up to view Page 66 - 70
70
I/O Schematic Diagram
Note:
Through the Web Configuration in the Trigger section, you must first enable
the trigger function.
Please refer to the Web Configuration section for detailed
information.
Warning
1.
When connecting a device to the Input connector, the device must be
a passive component without voltage and electrical current.
2.
When connecting other devices through the Output connector, please
make sure the maximum current of DC 5V, 100mA is strictly
observed.
3.
Any failure of the above two points might cause serious
damage to
the camera.
Page 72 / 83
71
Upgrade Firmware
User’s can update firmware from the IPView application.
Select
“Camera”
>
“Properties”
and the
Camera Property
dialog box will appear.
Select the
Tools
tab and enter the full path of the firmware binary file name in the
Update Firmware field or you can click on the
“Browse”
icon to select the file.
Once the firmware file is entered click on the
“Update”
icon to proceed with
the updating process.
Once completed click on the
“OK”
icon as illustrated
below
Warning
The download firmware procedure cannot be interrupted. If the network
connection is broken during the download procedure it might possibly cause
serious damage to the Internet Camera.
Page 75 / 83
74
Xplug Control Installation
Installation To Web Server
1.
Installation:
Copy the “xplug.ocx” file to any WEB Server table.
2.
Setting
(Configuration):
From the Web Configuration menu select “System” and under the
“Loading ActiveX From” input web server location
(http://www.web server location.com/).
Once the settings are completed the user now is able to access the Internet
Camera from the web browser by selecting the image view – ActiveX mode.
Note:
Set your browser security level to “Low”.
Important Information
It is highly recommended to install the Xplug Control application to the
Web Server for IE 5.0.
It must be installed to a Public Domain with
Fixed IP address.
19216811.live