²³

D-Link DAP-1350 User Manual

Section 3 - Configuration

Select

PBC

to use the Push Button Configuration to

connect to your network.

Click

Connect

to continue.

Note:

You may also press the WPS button located

on the side of the DAP-1350 instead of running this

wizard.

On the device you want to connect to, start the PBC

process on the device. You will have 2 minutes to

start the PBC process on both devices.

²´

D-Link DAP-1350 User Manual

Section 3 - Configuration

Select

Manual

configuration to setup your network

manually.

Click

Next

to continue.

Enter the network name (SSID) of the network you

want to connect to. If you do not know the exact name

or would like to search for the wireless network, click

Site Survey

.

Find your access point from the list, click the radio

button in the right column, and click

Connect

.

²µ

D-Link DAP-1350 User Manual

Section 3 - Configuration

If you select

WPA

or

WPA2

, enter the wireless

security password. Click

Next

to complete the Setup

Wizard.

The Wireless Setup Wizard is complete. Click

Finish

to reboot the device.

²¶

D-Link DAP-1350 User Manual

Section 3 - Configuration

Manual Wireless Setup

Wireless Mode:

Site Survey:

Wireless Type:

Wireless Network

Name:

Wireless Channel:

802.11 Mode:

Channel Width:

Transmission Rate:

Wireless MAC

Clone:

Wireless Security

Mode:

WPS:

Wireless Client Mode

is selected.

Click

Site Survey

to display a list of wireless networks in your

area. You may select the wireless access point to connect to.

Select

Infrastructure

if connecting to an access point or

wireless router, or select

Ad-Hoc

if connecting to another

wireless client.

Enter the SSID of the wireless network you want to connect

to. If you do not know for sure, click

Site Survey

and select it

from the list, if available.

The channel will automatically change to the channel of the AP

you are connected to.

Select the appropriate 802.11 mode based on the wireless

clients in your network. Select

Mixed 802.11b/g

,

802.11n Only

,

or

Mixed 802.11b/g/n

from the drop-down menu.

Select the Channel Width:

Auto 20/40

- Select if you are using both 802.11n and non-

802.11n wireless devices.

20MHz

- Select if you are not using any 802.11n wireless

clients.

Select the transmission rate. It is strongly suggested to use the Auto setting for optimal performance.

You can clone the MAC address of the device connected via Ethernet to the DAP-1350.

Select a wireless security setting. Options are

None

,

WEP

,

WPA

, or

WPA2

. See the Wireless Security section in this manual

for a detailed explanation of the wireless security options.

Select enable if you want to configure the DAP-1350 with Wi-Fi Protection setup.

50

D-Link DAP-1350 User Manual

Section 3 - Configuration

LAN Settings

This section will allow you to change the local network settings of the access point and to configure the DHCP

settings.

LAN Connection

Type:

IP Address:

Subnet Mask:

Default Gateway:

Device Name:

Use the drop-down menu to select

Dynamic

IP

(DHCP) to automatically obtain an IP

address on the LAN/private network or select

Static IP

to manually enter the IP settings.

192.168.0.50 is the default IP Address of the

DAP-1350.

255.255.255.0 is the default subnet mask.

All devices on the network must have the

same subnet mask to communicate on the

network.

Enter the IP Address of the gateway in your

network.

Enter the Device Name of the AP. It is

recommended to change the Device Name if

there is more than one D-Link device within

the subnet.