Page 31 / 134
Scroll up to view Page 26 - 30
DG-BG4100N User
Manual
31
Click
BACK
to modify the settings.
Click
FINISH
to save the settings.
Click
RESET
to cancel the settings.
Note:
If
the WAN connection type is set to PPPoA, the parameters of the WAN
connection type are the same as that of PPPoE.
1483 MER / 1483 Routed
In the Connection Type page, set the WAN connection type to 1483 MER, the encapsulation
mode to LLC/SNAP.
After the settings are done, click
Next
, the page as shown in the following figure appears.
Page 32 / 134
DG-BG4100N User
Manual
The following table describes the parameters in this page:
32
Field
Description
Obtain an IP address
automatically
Select it, DHCP automatically assigns the IP
address for WAN connection.
Use the following IP address
Select it, you need to manually enter the IP
address, subnet mask and default gateway for
WAN connection, which are provided by your ISP.
Obtain DNS server
addresses automatically
Select it, DHCP automatically assigns DNS server
address.
Use the following DNS server
addresses
Select it, you need to manually enter the primary
DNS server address and secondary DNS server
address.
Enable NAT
Select it to enable network address translation
(NAT). If you do not select it and you want to
access the Internet normally, you must add a route
Page 33 / 134
DG-BG4100N User
Manual
33
on the uplink equipment. Otherwise, the access to
the Internet fails. Normally, it is required to enable
NAT.
For subsequent configuration, refer to the description in the above section PPPoE/PPPoA.
Note:
If the WAN connection type is set to 1483 Routed, the parameters of the WAN connection
type
are the same as that of 1483 MER. For the parameters in these pages, refer to the
parameter
description of 1483 MER.
1483 Bridged
In the Connection Type page, set the WAN connection type to 1483 Bridged, the
encapsulation mode to LLC/SNAP.
Page 34 / 134
DG-BG4100N User
Manual
34
After the settings are done, click
Next
, the page as shown in the following figure appears.
The following table describes the parameters in this page:
Field
Description
LAN Interface Setup
LAN IP
Enter the IP address of LAN interface. Its valid value is in
the range of
192.168.1.1 to 192.168.255.254. The default
LAN Netmask
Enter the subnet mask of LAN interface. Its valid value is
in the range of 255.255.0.0 to 255.255.255.254.
Enable Secondary IP
Select the checkbox to enable the secondary LAN IP. The
two LAN IP addresses must be in the different network.
Page 35 / 134
DG-BG4100N User
Manual
35
DHCP Server
Enable DHCP Server
Select the checkbox to enable DHCP server.
Start IP
Enter the start IP address that the DHCP sever assigns.
End IP
Enter the end IP address that the DHCP server assigns.
Max Lease Time
The lease time determines the period that the PCs retain
the assigned IP addresses before the IP addresses
change.
For subsequent configuration, refer to the description in the above section PPPoE/PPPoA.
Note:
You may configure at most eight ATM VCs. To add an ATM VC, refer
section 3.4.2.1WAN
19216811.live