Page 21 / 134
Scroll up to view Page 16 - 20
DG-BG4100N User
Manual
21
Configure the wireless security.
Click on ‘
Next
’ the following screen will appear.
Page 22 / 134
DG-BG4100N User
Manual
22
Click on ‘
Finish
’ to complete the configuration of the router in Bridge mode.
3
About the Web Configuration
This section describes how to configure the router by using the Web-based configuration
utility.
3.1
Access the Router
The following is the detailed description of accessing the router for the first time.
Step 1
Step 2
In the Login page that is displayed, enter the username and password.
The username and password of the super user are admin and admin.
The username and password of the common user are user and user.
Page 23 / 134
DG-BG4100N User
Manual
23
If you log in as a super user, the page shown in the following figure appears. You can check,
configure and modify all the settings.
If you log in as a common user, you can check the status of the router, but can not configure
most of the settings.
Note:
In the Web configuration page, you can click Apply Changes to save the settings temporarily.
If you want to save the settings of this page permanently, click save of Attention that appears
at the bottom of the Web page after the configuration.
Page 24 / 134
DG-BG4100N User
Manual
24
3.2
Wizard
When subscribing to a broadband service, you should be aware of the method by which you
are connected to the Internet. Your physical WAN device can be either PPP, ADSL or both.
The technical information about the properties of your Internet connection is provided by your
Internet Service Provider (ISP). For example, your ISP should inform you whether you are
connected to the Internet using a static or dynamic IP address, and the protocol that you use
to communicate on the Internet.
In the navigation bar, choose Wizard. The page shown in the following figure appears. The
Wizard page guides fast and accurate configuration of the Internet connection and other
important parameters. The following sections describe these various configuration
parameters. Whether you configure these parameters or use the default ones, click
NEXT
to
enable your Internet connection.
Page 25 / 134
DG-BG4100N User
Manual
25
The following table describes the parameters in this page:
Field
Description
VPI
Virtual path identifier (VPI) is the virtual path between two points in
an ATM network. Its valid value is in the range of 0 to 255. Enter the
correct VPI provided by your ISP. By default, VPI is set to 0.
VCI
Virtual channel identifier (VCI) is the virtual channel between two
points in an ATM network. Its valid value is in the range of 32 to
65535. (0 to 31 is reserved for local management of ATM traffic)
Enter the correct VCI provided by your ISP. By default, VCI is set to
35.
After setting, click
Next
, the page as shown in the following figure appears.
There are five WAN connection types: PPP over ATM (PPPoA), PPP over Ethernet (PPPoE),
1483 MER, 1483 Routed and 1483 Bridged. The following below describes them
respectively.
19216811.live