Page 116 / 272
Scroll up to view Page 111 - 115
Chapter 4
DSL Configuration
94
4036168 Rev B
To Test the Quality of the DSL Connection
The ADSL Bit Error Rate (BER) will report the quality of the ADSL connection. The
ADSL BER test results will show how many bits are sent and are erred among them.
To test for quality of the DSL connection:
1
Click
DSL
on the main screen.
2
Click the
Statistics
tab.
3
Click
ADSL BER Test
.
4
Enter the duration of the test in seconds for the Tested Time (sec).
5
Click
Start
to start the test.
To Reset DSL Statistics
To reset the statistics, click
Reset Statistics
button. This action will clear the numbers
and restart the calculation.
Page 117 / 272
DSL Diagnostics
4036168 Rev B
95
DSL Diagnostics
The Diagnostics screen shows the results of diagnostics tests that the residential
gateway performs while testing your DSL connection. The individual tests are listed
on the Diagnostics screen.
Path
:
DSL > Diagnostics
Page 118 / 272
Chapter 4
DSL Configuration
96
4036168 Rev B
Running Diagnostic Tests
To run diagnostic tests for the residential gateway, complete the following steps.
1
Click
DSL
on the main screen.
2
Click the
Diagnostics
tab. The Diagnostics screen opens.
3
Click
Rerun Diagnostics Tests
to start the diagnostics test. The screen populates
with results such as Fail or Pass.
Page 119 / 272
DSL Diagnostics
4036168 Rev B
97
4
When you have a Permanent Virtual Circuit (PVC) up, for example an MER
connection as shown in the screen-shot below, then you can see a list of other
tests such as OAM F4/F5 or the PING test appear on the DSL Diagnostics page.
You can click
Test with OAM F4
to run a OAM F4 test.
Page 120 / 272
Chapter 4
DSL Configuration
98
4036168 Rev B
DSL Settings
The DSL Settings screens allow you to configure slave and master settings for the
residential gateway.
DSL Slave Settings
The DSL Slave Settings screen allows you to set the modulation for the residential
gateway, select a phone line pair, and to select advanced capability of the chip set:
Seamless Rate Adaptation (SRA), Bitswap Enable, PhyR, and so forth.
Path
:
DSL > Setting > DSL Slave Settings
19216811.live