23

LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown in

the table.

IPv4

LAN Port

WAN Port

IPv4 address

192.168.1.254

Subnet Mask

255.255.255.0

DHCP server function

Enabled

IP addresses for

distribution to PCs

20 IP addresses continuing

from 192.168.1.1 through

192.168.1.20

The PPPoE function is

enabled to automatically get

the WAN port configuration

from the ISP.

24

Information from your ISP

Before configuring this device, you have to check with your ISP (Internet Service Provider) to find

out what kind of service is provided such as DHCP (Obtain an IP Address Automatically, Static IP

(Fixed IP Address) or PPPoE.

Gather the information as illustrated in the following table and keep it for reference.

PPPoE(RFC2516)

VPI/VCI, VC / LLC-based multiplexing, Username, Password, Service

Name, and Domain Name System (DNS) IP address (it can be

automatically assigned by your ISP when you connect or be set manually).

PPPoA(RFC2364)

VPI/VCI, VC / LLC-based multiplexing, Username, Password and Domain

Name System (DNS) IP address (it can be automatically assigned by your

ISP when you connect or be set manually).

IPoA(RFC1577)

VPI/VCI, VC / LLC-based multiplexing, IP address, Subnet mask, Gateway

address, and Domain Name System (DNS) IP address (it is a fixed IP

address).

IP over Ethernet

(RFC1483/RFC2684

)

VPI/VCI, VC / LLC-based multiplexing, IP address, Subnet mask, Gateway

address, and Domain Name System (DNS) IP address (it can be

automatically assigned by your ISP when you connect or set manually).

Pure Bridge

VPI/VCI, VC / LLC-based multiplexing to use Bridged Mode.

25

Configuration via Web Interface

Open your web browser; enter the IP address of your router, which by default is 192.168.1.254, and

click

or press ‘Enter’ key on the keyboard, a login prompt window will appear. The default root

username and password are “admin” and “admin” respectively.

Congratulations! You are now successfully logged in to the Firewall Router!

After logging in to the router you will see Quick Start Wizard as shown below, please follow the steps

on following pages to configure your device.

26

Quick Start

This part is to let you quickly configure and start your router to access internet.

1.

Select DSL,

press

Continue

to go on to next step, or if you only want to configure Wireless, press

Jump to Wireless setting

to go to step 8. Click

Quick Setup

to give up and return to the Device

Info page.

2.

When ADSL line is not ready, the screen1 below will appear to remind you. Then you should

connect the ADSL line. While ADSL line is ready, the screen 2 below will appear to let you go on.

Here you can select Auto or Manually. Select Auto will go to step 3, and select manually will go to

step 4.

Screen 1

Screen 2

3.

Here wait while the DSL is scanning, when the scanning is OK, the scanning result will appear,

see screen 3, and then it will quickly go to step 6. If the scanning fails, you will also be lead to step 4.

Screen 3

27

4.

Here you should select the Layer2 Interface, ATM. Click

Add

to add WAN Interface.

5.

According to your ISP, type the VPI/VCI, select appropriate Link type and the Encapsulation mode.

Click Continue to go to next step.

6.

Enter the username, password from your ISP, for IP and DNS settings, also refer to your ISP.

Click Continue to go on.