Page 31 / 59
Scroll up to view Page 26 - 30
29
ADDITIONAL CAPABILITIES
Intellistream QoS
Intellistream prioritizes video and gaming traffic for
a better online entertainment experience.
There are two ways to enable Intellistream:
Run a Speed Test:
In order for Intellistream to provide you the best media experience,
your Router needs to know what your approximate Internet speeds are.
Click “Run a Speed Test” and the test will begin.
Once complete you will see the results.
Page 32 / 59
30
ADDITIONAL CAPABILITIES
If your Internet speed is greater than 70Mbps when downloading,
Intellistream QoS will only improve your uploading experience.
Refresh –
This will retest your Internet speed.
When you click “Save,” your Router will save your changes.
Page 33 / 59
31
ADDITIONAL CAPABILITIES
When you click “Save,” your Router will save your changes.
Intellistream is now enabled.
Manual set –
This will let you set your approximate Internet speeds.
If you do not know your Internet speeds, contact your ISP.
Page 34 / 59
32
ADDITIONAL CAPABILITIES
IPv6 Configuration
A new version of Internet Protocol (IP) uses a
128-bit address to implement additional features
that are not present in current IP addresses.
Contact your ISP to inquire about their support for IPv6.
Pass-Through
Devices connected to your Router can talk to each other using
native IPv6 packets, but information will be sent to all connected
devices. Pass-through is not efficient and is not recommended for
consistent use.
Page 35 / 59
A
B
33
GETTING TO KNOW YOUR ROUTER
A) Router Status Light
Your Router’s status is shown by the light on the front.
Off:
The Router is not plugged into a power source.
Blinking Blue:
The Router is starting up.
Solid Blue:
The Router is connected to the Internet.
Blinking Amber:
The Router can’t detect the modem. Either the
modem is off, is not plugged into the Router, or is unresponsive.
B) Wi-Fi Protected Setup (WPS) Light and Button
The WPS button on the front of your Router can be
used to help establish a secure connection between
your Router and other WPS-enabled Wi-Fi devices
such as computers. To use WPS, refer to page 9.
The small light near the WPS button shows what is happening
while you are using WPS to establish a connection.
Off:
Idle
Blinking Blue:
The Router is listening for a WPS-
enabled computer or other device.
Solid Blue:
The Router has made a secure
connection with the computer or other device.
Amber:
A connection was not created.
Front Panel
19216811.live