TROUBLESHOOTING, SUPPORT, AND WARRANTY

How to get service°

To get service for your Belkin product you

must take the following steps:

1°

Contact Belkin International, Inc°, at 12045 E° Waterfront

Drive, Playa Vista, CA 90094, Attn: Customer Service, or

call (800)-223-5546, within 15 days of the Occurrence°

Be prepared to provide the following information:

a° The part number of the Belkin product°

b° Where you purchased the product°

c° When you purchased the product°

d° Copy of original receipt°

2°

Your Belkin Customer Service Representative will then

instruct you on how to forward your receipt and Belkin

product and how to proceed with your claim°

Belkin reserves the right to review the damaged Belkin product°

All costs of shipping the Belkin product to Belkin for inspection

shall be borne solely by the purchaser° If Belkin determines,

in its sole discretion, that it is impractical to ship the damaged

equipment to Belkin, Belkin may designate, in its sole discretion,

an equipment repair facility to inspect and estimate the cost to

repair such equipment° The cost, if any, of shipping the equipment

to and from such repair facility and of such estimate shall be

borne solely by the purchaser° Damaged equipment must remain

available for inspection until the claim is finalized° Whenever

claims are settled, Belkin reserves the right to be subrogated

under any existing insurance policies the purchaser may have°

TROUBLESHOOTING, SUPPORT, AND WARRANTY

How state law relates to the warranty°

THIS WARRANTY CONTAINS THE SOLE WARRANTY OF

BELKIN° THERE ARE NO OTHER WARRANTIES, EXPRESSED

OR, EXCEPT AS REQUIRED BY LAW, IMPLIED, INCLUDING

THE IMPLIED WARRANTY OR CONDITION OF QUALITY,

MERCHANTABILITY OR FITNESS FOR A PARTICULAR

PURPOSE, AND SUCH IMPLIED WARRANTIES, IF ANY, ARE

LIMITED IN DURATION TO THE TERM OF THIS WARRANTY°

Some states do not allow limitations on how long an implied

warranty lasts, so the above limitations may not apply to you°

IN NO EVENT SHALL BELKIN BE LIABLE FOR INCIDENTAL,

SPECIAL, DIRECT, INDIRECT, CONSEQUENTIAL OR

MULTIPLE DAMAGES SUCH AS, BUT NOT LIMITED TO,

LOST BUSINESS OR PROFITS ARISING OUT OF THE

SALE OR USE OF ANY BELKIN PRODUCT, EVEN IF

ADVISED OF THE POSSIBILITY OF SUCH DAMAGES°

This warranty gives you specific legal rights, and you may also have

other rights, which may vary from state to state° Some states do

not allow the exclusion or limitation of incidental, consequential,

or other damages, so the above limitations may not apply to you°

REGULATORY INFORMATION

FCC Statement

DECLARATION OF CONFORMITY WITH FCC RULES

FOR ELECTROMAGNETIC COMPATIBILITY

We, Belkin International, Inc°, of 12045 E° Waterfront Drive, Playa

Vista, CA 90094, declare under our sole responsibility that the device,

F7D6301 v1,

complies with Part 15 of the FCC Rules° Operation is

subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation°

Caution: Exposure to Radio Frequency Radiation°

The device shall be used in such a manner that the potential

for human contact normal operation is minimized

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment° This

equipment should be installed and operated with a minimum

distance of 20cm between the radiator and your body°

Federal Communications Commission Notice

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules° These limits are designed to provide reasonable protection

against harmful interference in a residential installation°

This equipment generates, uses, and can radiate radio frequency

energy, and if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications°

However, there is no guarantee that interference will not occur

in a particular installation° If this equipment does cause harmful

interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try and

correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the distance between the equipment and the receiver.

•

Connect the equipment to an outlet on a circuit different

from that to which the receiver is connected°

•

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly

approved by the party responsible for compliance could

void the user’s authority to operate this equipment°

This device and its antenna(s) must not be co-located or

operating in conjunction with any other antenna or transmitter°

REGULATORY INFORMATION

Canada-Industry Canada (IC)

The wireless radio of this device complies with RSS

139 & RSS 210 Industry Canada° This Class B digital

apparatus complies with Canadian ICES-003°

Operation is subject to the following two conditions: (1)

this device may not cause interference, and (2) this device

must accept any interference, including interference

that may cause undesired operation of the device°

Cet appareil numérique de la classe B conforme

á la norme NMB-003 du Canada°

Europe

European Union Radio products with the CE or CE alert

marking comply with the R&TTE Directive (1999/5/EC)

issued by the Commission of the European Community°

Compliance with this directive implies conformity

to the following European Norms (in brackets are

the equivalent international standards)°

•

EN 60950-1:2006 (IEC60950-1) – Product Safety

•

EN 300 328 Technical requirement for radio equipment

•

ETS 301 489 General EMC requirements for radio equipment.

Information

Products with the CE marking comply with the EMC Directive

(2004/108/EC) and the Low Voltage Directive (2006/95/

EC) issued by the Commission of the European Community°

Compliance with these directives implies conformity to

the following European Product Family Standards°

•

EN 55022 (CISPR 22) – Electromagnetic Interference

•

EN 55024-1 – Electromagnetic Immunity

•

EN 61000-3-2 (IEC610000-3-2) – Power Line Harmonics

•

EN 61000-3-3 (IEC610000) – Power Line Flicker

•

EN 60950-1 (IEC60950-1) – Product Safety

Products that contain the radio transmitter are sometimes

labeled with the Notified Body number (CE0560) or CE

alert marking if the standard used in the conformity is

not harmonized across the European Community°

© 2010 Belkin International, Inc° All rights reserved° All trade names are registered trademarks

of respective manufacturers listed° Mac and Mac OS are trademarks of Apple Inc°, registered

in the U°S° and other countries° Windows and Windows Vista are either registered trademarks

or trademarks of Microsoft Corporation in the United States and/or other countries°