Page 26 / 30 Scroll up to view Page 21 - 25
24
TROUBLESHOOTING, SUPPORT, AND WARRANTY
How to get service°
To get service for your Belkin product you
must take the following steps:
Contact Belkin International, Inc°, at 12045 Waterfront
Drive, Los Angeles, CA 90094, Attn: Customer Service,
or call (800)-223-5546, within 15 days of the Occurrence°
Be prepared to provide the following information:
a° The part number of the Belkin product°
b° Where you purchased the product°
c° When you purchased the product°
d° Copy of original receipt°
Your Belkin Customer Service Representative will then
instruct you on how to forward your receipt and Belkin
product and how to proceed with your claim°
Belkin reserves the right to review the damaged Belkin product°
All costs of shipping the Belkin product to Belkin for inspection
shall be borne solely by the purchaser° If Belkin determines,
in its sole discretion, that it is impractical to ship the damaged
equipment to Belkin, Belkin may designate, in its sole discretion,
an equipment repair facility to inspect and estimate the cost to
repair such equipment° The cost, if any, of shipping the equipment
to and from such repair facility and of such estimate shall be
borne solely by the purchaser° Damaged equipment must remain
available for inspection until the claim is finalized° Whenever
claims are settled, Belkin reserves the right to be subrogated
under any existing insurance policies the purchaser may have°
Page 27 / 30
25
TROUBLESHOOTING, SUPPORT, AND WARRANTY
How state law relates to the warranty°
THIS WARRANTY CONTAINS THE SOLE WARRANTY OF
BELKIN° THERE ARE NO OTHER WARRANTIES, EXPRESSED
OR, EXCEPT AS REQUIRED BY LAW, IMPLIED, INCLUDING
THE IMPLIED WARRANTY OR CONDITION OF QUALITY,
MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, AND SUCH IMPLIED WARRANTIES, IF ANY, ARE
LIMITED IN DURATION TO THE TERM OF THIS WARRANTY°
Some states do not allow limitations on how long an implied
warranty lasts, so the above limitations may not apply to you°
IN NO EVENT SHALL BELKIN BE LIABLE FOR INCIDENTAL,
SPECIAL, DIRECT, INDIRECT, CONSEQUENTIAL OR
MULTIPLE DAMAGES SUCH AS, BUT NOT LIMITED TO,
LOST BUSINESS OR PROFITS ARISING OUT OF THE
SALE OR USE OF ANY BELKIN PRODUCT, EVEN IF
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES°
This warranty gives you specific legal rights, and you may also have
other rights, which may vary from state to state° Some states do
not allow the exclusion or limitation of incidental, consequential,
or other damages, so the above limitations may not apply to you°
Page 28 / 30
26
REGULATORY INFORMATION
FCC Statement
DECLARATION OF CONFORMITY WITH FCC RULES
FOR ELECTROMAGNETIC COMPATIBILITY
We, Belkin International, Inc°, of 12045 Waterfront Drive, Los Angeles,
CA 90094, declare under our sole responsibility that the device,
F7D1301 v1
, complies with Part 15 of the FCC Rules° Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation°
Caution: Exposure to Radio Frequency Radiation°
The device shall be used in such a manner that the potential
for human contact normal operation is minimized
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment° This
equipment should be installed and operated with a minimum
distance of 20cm between the radiator and your body°
Federal Communications Commission Notice
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules° These limits are designed to provide reasonable protection
against harmful interference in a residential installation°
This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications°
However, there is no guarantee that interference will not occur
in a particular installation° If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected°
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate this equipment°
This device and its antenna(s) must not be co-located or
operating in conjunction with any other antenna or transmitter°
Page 29 / 30
27
REGULATORY INFORMATION
Canada-Industry Canada (IC)
The wireless radio of this device complies with RSS
139 & RSS 210 Industry Canada° This Class B digital
apparatus complies with Canadian ICES-003°
Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device
must accept any interference, including interference
that may cause undesired operation of the device°
Cet appareil numérique de la classe B conforme
á la norme NMB-003 du Canada°
Europe
European Union Radio products with the CE or CE alert
marking comply with the R&TTE Directive (1999/5/EC)
issued by the Commission of the European Community°
Compliance with this directive implies conformity
to the following European Norms (in brackets are
the equivalent international standards)°
EN 60950-1:2006 (IEC60950-1) – Product Safety
EN 300 328 Technical requirement for radio equipment
ETS 301 489 General EMC requirements for radio equipment.
Information
Products with the CE marking comply with the EMC Directive
(2004/108/EC) and the Low Voltage Directive (2006/95/
EC) issued by the Commission of the European Community°
Compliance with these directives implies conformity to
the following European Product Family Standards°
EN 55022 (CISPR 22) – Electromagnetic Interference
EN 55024-1 – Electromagnetic Immunity
EN 61000-3-2 (IEC610000-3-2) – Power Line Harmonics
EN 61000-3-3 (IEC610000) – Power Line Flicker
EN 60950-1 (IEC60950-1) – Product Safety
Products that contain the radio transmitter are sometimes
labeled with the Notified Body number (CE0560) or CE
alert marking if the standard used in the conformity is
not harmonized across the European Community°
Page 30 / 30
© 2010 Belkin International, Inc° All rights reserved° All trade names are registered trademarks
of respective manufacturers listed° Mac and Mac OS are trademarks of Apple Inc°, registered
in the U°S° and other countries° Windows and Windows Vista are either registered trademarks
or trademarks of Microsoft Corporation in the United States and/or other countries°

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top