19216811.live14
N Wireless Modem Router
SECTIONS
Table of Contents
1
2
3
5
6
7
8
9
10
4
CONNECTING AND CONFIGURING YOUR MODEM ROUTER
2
1
4
5
3
1°1 Brand-New Setup
Follow these steps if you are not replacing an existing modem° If you are
replacing an existing modem, skip to the next section, “Replacing an
Existing Modem or Modem Router”, starting on page 15°
1
° Unpack your new Router from the box and place it next to your
computer° Raise the Router’s antennas°
2°
Retrieve the yellow RJ45 cable that was included with your
Router° First, connect one end to any yellow port labeled “Wired”
on the back of your Router° Then, connect the other end to the
networking port on the back of your computer°
3°
Retrieve the included gray RJ11 phone cord° Connect one end to
the gray port labeled “ADSL line” on the back of your Router° Then
connect the other end to your ADSL connection (either a wall jack
or an ADSL splitter)°
Note:
Some ADSL connections require a micro filter° Your ADSL provider
can tell you if you need one° Belkin includes a micro filter in regions
known to use them° You may or may not have received one in your box°
4°
Plug your Router’s power supply into the black port labeled
“Power” on the back of your Router°
5°
Wait 20 seconds for the Router to start up° Look at the display on
the front of the Router° Make sure the “Wired” and “Router” icons
are lit up in blue° If they are not, recheck your connections°
Step 1: Hardware Connections