30
802.11g and 802.11b, device in your network, select
Deactived.
SSID:
The SSID is the unique name of a wireless access point (AP) to be distinguished
from another.
For security propose, change the default
wlan-ap
to
a unique ID name to the
AP which is already built-in to the router’s wireless interface. It is case sensitive and must
not excess 32 characters. Make sure your wireless clients have exactly the SSID as the
device, in order to get connected to your network.
Broadcast SSID:
Select
Yes
to hide the SSID in so a station cannot obtain the SSID
through passive scanning. Select
No
to make the SSID visible so a station can obtain the
SSID through passive scanning.
Channel ID:
The range of radio frequencies used by IEEE 802.11b/g wireless devices is
called a channel. Select a channel from the drop-down list box.
Authentication Type:
To prevent unauthorized wireless stations from accessing data
transmitted over the network, the router offers highly secure data encryption, known as
WEP.&WPA. If you require high security for transmissions, there are two alternatives to
select from:
64-bit WEP and 128-bit WEP
. WEP 128 will offer increased security over WEP
64.
You can disable or enable with WPA or WEP for protecting wireless network. The default
type of wireless is
disabled
and to allow all wireless computers to communicate with the
access points without any data encryption
Advanced Setting
Beacon interval:
The Beacon Interval value indicates the frequency interval of the
beacon. Enter a value between 20 and 1000. A beacon is a packet broadcast by the Router
to synchronize the wireless network.
RTS/CTS Threshold:
The RTS (Request To Send) threshold (number of bytes) for
enabling RTS/CTS handshake. Data with its frame size larger than this value will perform
the RTS/CTS handshake. Setting this attribute to be larger than the maximum MSDU (MAC
service data unit) size turns off the RTS/CTS handshake. Setting this attribute to zero turns
on the RTS/CTS handshake
Enter a value between 1500 and 2347..
Fragmentation Threshold:
The threshold (number of bytes) for the fragmentation
boundary for directed messages. It is the maximum data fragment size that can be sent.
Enter a value between 256 and 2346.
DMIT:
This value, between 1 and 255, indicates the interval of the Delivery Traffic
Indication Message (DTIM).
802.11b/g:
The default setting is
802.11b+g
(Mixed mode). If you do not know or have
both 11g and 11b devices in your network, then keep the default in
mixed mode
.
From the
drop-down manual, you can select
802.11g
if you have only 11g card.
If you have only 11b
card, then select
802.11b
.
19216811.live