Page 51 / 63 Scroll up to view Page 46 - 50
49
4.5 Maintenance
4.5.1 Administrator
In factory setting, the default password is
admin
, and that for user is also password. You can
change the default password to ensure that someone cannot adjust your settings without
your permission. Every time you change your password, please record the password and
keep it at a safe place.
New Password:
Type the new password in this field
Confirm Password:
Type the new password again in this field.
Page 52 / 63
50
4.5.2 Time Zone
The router does not have a real time clock on board; instead, it uses the Simple Network
Time Protocol (SNTP) to get the current time from an SNTP server outside your network.
Choose your local time zone. After a successful connection to the Internet, the router will
retrieve the correct local time from the SNTP server you have specified. If you prefer to
specify an SNTP server other than those in the drop-down list, simply enter its IP address as
shown above. Your ISP may provide an SNTP server for you to use.
Synchronize time with:
Select the time service protocol that your time server sends
when you turn on the Router.
Time Zone:
Choose the time zone of your location. This will set the time difference
between your time zone and Greenwich Mean Time (GMT).
Daylight Saving:
Select this option if you use daylight savings time
NTP Server Address:
Enter the IP address of your time server. Check with your
ISP/network administrator if you are unsure of this information.
Page 53 / 63
51
DO NOT power down the router or interrupt the firmware upgrading while
it is still in process.
Improper operation could damage the router.
Warning
4.5.3 Firmware
Your router’s “firmware” is the software that allows it to operate and provides all its
functionality. Think of your router as a dedicated computer, and the firmware as the software
it runs. Over time this software may be improved and modified, and your router allows you to
upgrade the software it runs to take advantage of these changes.
To upgrade the firmware of 5200 Series, you should download or copy the firmware to your
local environment first. Press the
“Browse…”
button to specify the path of the firmware file.
Then, click
“Upgrade”
to start upgrading. When the procedure is completed, 5200 Series
will reset automatically to make the new firmware work.
New Firmware Location:
Type in the location of the file you want to upload in this field or
click
Browse
to find it.
Browse:
Click
Browse...
to find the .ras file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
UPGRADE
: Click
UPGRADE
to begin the upload process. This process may take up to
two minutes.
After two minutes, log in again and check your new firmware version in the System Status
screen.
If the upload was not successful, the following screen will appear. Click Back to go back to
the Firmware screen.
Page 54 / 63
52
4.5.4 SysRestart
Click
SysRestart
with option
Current Settings
to reboot your router (and restore your last
saved configuration).
If you wish to restart the router using the factory default settings (for example, after a
firmware upgrade or if you have saved an incorrect configuration), select
Factory Default
Settings
to reset to factory default settings.
You may also reset your router to factory settings by holding the small Reset pinhole button
on the back of your router in for 10-12 seconds whilst the router is turned on.
Page 55 / 63
53
4.5.6 Diagnostics
The Diagnostic Test page shows the test results for the connectivity of the physical layer and
protocol layer for both LAN and WAN sides

Rate

4 / 5 based on 1 vote.

Popular BEC Technologies Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top