Page 6 / 65 Scroll up to view Page 1 - 5
Package Contents
5
7
Power Receptor
Receptor for the Power Adaptor.
8
UMTS LED
Reference below table.
9
Roaming LED
Solid light shows the Router is connecting to
Roaming network.
10
WLAN LED
Solid light indicates that the wireless segment is
ready.
Flashing light shows that data is being
transmitted via WLAN.
11
Ethernet LED
Solid light shows that an Ethernet-enabled
computer is connected via the LAN port but no
data is being transmitted.
Flashing light shows that data is being
transmitted via LAN.
12
DIAG LED
Reference below table.
13
Power LED
Solid light indicates that the power supply is
connected properly.
14
3G Radio On/Off &
Signal Strength
Button
Short press – Enable Signal Strength indication
for 3 sec.
Long press (>5 sec) – 3G radio on/off
15
3G Radio Signal
Strength Indicator
Indicates the 3G signal strength when 3G Radio
button is in short press.
Table for UMTS and DIAG LED:
Operation status
UMTS
DIAG
Error in Router
OFF
Solid
Fail to boot module
Solid Red
Flashing
No SIM exist
Flashing Red
OFF
Waiting for PIN entering
Flashing Red
OFF
No network/Searching for network
Flashing Red
OFF
3G camped
Flashing Green/Pink
OFF
3G connected
Solid Blue/Green/Pink
OFF
Note: Pink for UMTS LED is available by product if 2G is available.
Page 7 / 65
Installation
6
Installation
1.
Connect the power adaptor to the Router and connect it to an outlet.
2.
Insert your SIM card into the slot on the Router, making sure the SIM
card orientation matches the SIM card slot, as shown in the picture.
3.
Turn on the Power switch.
Page 8 / 65
Installation
7
4.
One of the following two methods can be chosen to link your Router
with PC.
A.
To link the Router with your PC via WiFi, in Microsoft Windows, go to
Control Panel
>
Network Connections
, right-click on
Wireless
Network Connection
, and choose
View Available Wireless
Networks
. Select the
HSPA_ROUTER
wireless network, and click
Connect
.
B.
To link the Router with your PC via Ethernet cable, connect one end
of the cable to the LAN port on the Router, and the other end of the
cable to the Ethernet port on your computer.
.
Note:
If you choose to access the Internet via Ethernet,
connect one end of the cable to the WAN port of Router, and
the other end to your xDSL/Cable Modem.
The
Router uses a web-based configuration utility. To access the
configuration utility, open a browser (for example Internet Explorer) and
enter the IP address (
http:
//
192.168.1.1
) or the URL
Page 9 / 65
Installation
8
(
http://R300.ROUTER
)
for the Router in your browser’s address bar.
Enter the Router User name (
admin
) and Password (
hsparouter
).
Page 10 / 65
Wizard Setup
9
Wizard Setup
User can set preferred settings step by step via Wizard. If the router is in
Factory default settings, the GUI will always open Wizard. User can set
the Wizard via Basic Setting> Network Setting > Basic WiFi Network >
WiFi Security.

Rate

4.5 / 5 based on 2 votes.

Popular Bandluxe Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top