Page 96 / 111
Scroll up to view Page 91 - 95
A-LINK WNAP4G
User Manual
96
the changes.
6.3.4 Others
In this section you can do system backup, reset to default, system reboot settings
and ping test.
6.3.4.1
Backup Settling
You can backup your settings by clicking the “
Backup Setting”
function item and
save it as a bin file. Once you want to restore these settings, please click
Firmware Upgrade button and use the bin file you saved.
Page 97 / 111
A-LINK WNAP4G
User Manual
97
6.3.4.2
Reset to Default
You can also reset this device to factory default settings by clicking the
”
Reset to
default
”
function item.
6.3.4.3
Reboot
You can also reboot this device by clicking the
“
Reboot
”
function item.
6.3.4.4
Domain Name or IP Address for Ping Test
1.
Domain Name or IP address for Ping Test
allow you to configure an IP,
Page 98 / 111
A-LINK WNAP4G
User Manual
98
and ping the device. You can ping a specific IP to test whether it is alive.
Afterwards, click on
“Save”
to store your settings or click
“Undo”
to give up
the changes.
6.4 Scheduling
You can set the schedule time to decide which service will be turned on or off. The added
rules will be listed and you can decide if you want to enable the set rules by checking or
un-
checking the “Enable” box
in the icon below.
Add New Rule
: To create a schedule rule, click the “New Add” button
or the “Add New
Rule…” button at the bottom in the icon above
. When the next icon popped out you can
edit the
Name of Rule
,
Policy
, and set the schedule time (
Week day
,
Start Time
, and
End Time
). The following example configures “wake
-
up time“ e
veryday from 06:00 to
07:00.
Afterwards, click
“save”
to store your settings or click
“Undo”
to give up the
changes.
Page 99 / 111
A-LINK WNAP4G
User Manual
99
6.5 MMI
You can set UI administration time-out duration give remote administration host port in
this page. When the host port is given please remember to check the enable box and
save your settings.
Page 100 / 111
A-LINK WNAP4G
User Manual
100
Chapter 7
Troubleshooting
This Chapter provides solutions to problems for the installation and operation of the
WNAP4G Router. You can refer to the following if you are having problems.
1 Why c
an’t I configure the router even the cable is plugged
and the LED is lit?
Do a
Ping test
to make sure that the WiFi
Broadband Router is responding.
Go to
Start > Run
.
1.
Type
cmd
.
2.
Press
OK.
3.
Type
ipconfig
to get the IP of default gateway.
4.
Type “
ping 192.168.1
.254”.
Assure that you ping the correct IP Address
assigned to the WiFi Broadband Router. It will show four replies if you ping
correctly.
Note:
It is recommended that you
use an
Ethernet connection to
configure it
19216811.live