Page 6 / 80
Scroll up to view Page 1 - 5
7
Back Panel
Item
Name
Description
Antenna
The antenna is 3dBi dipole antenna.
Radio
ON/OFF
Switch the button to activate or deactivate the Router’s wireless function.
LED
Light
Status
Description
POWER
On
Router is powered on.
On
WPS setup is in progress.
Off
Wireless network is switched off.
WLAN
Flashing
Wireless network is ready and WPS setup is not in
progress.
On
WAN port is connected.
Off
WAN port is not connected.
WAN
LNK/ACT
Flashing
WAN port is transferring or receiving data.
On
LAN port is connected.
Off
LAN port is not connected.
LAN 1-4
LNK/ACT
Flashing
LAN port is transferring or receiving data.
Page 7 / 80
8
Reset /
WPS
Reset the router to factory default settings (clear all settings) or start security
synchronization function (WPS). Press this button and hold for 10 seconds to
restore all settings to factory defaults. Press this button for no longer than 1
second to start security synchronization.
1 - 4
Local Area Network (LAN) ports 1 to 4.
WAN
Wide Area Network (WAN / Internet) port.
Power
Power connector, connects to A/C power adapter.
Page 8 / 80
9
Chapter 2 Installing the Router
2.1 Using EZ Setup Wizard
Step 1
Insert the Setup CD into your CD-ROM drive.
Step 2
Click
Next
to start the configuration.
Page 9 / 80
10
Step 3
Connect one end of a network cable to the WAN port of the router and connect the other
end to your DSL/Cable modem.
Step 4
Connect one end of another network cable to the LAN port of the router and connect the
other end to your computer.
Page 10 / 80
11
Step 5
Power on the Router. It will take about 30 seconds.
Step 6
Make sure
POWER
,
WAN
,
WLAN
, and the
LAN
port that the computer is connected to
are lit. If not, try the above steps again.
Step 7
Enter the Router’s password to log in to the Router. The default password is “admin”. It
is recommended to change the router’s password to protect it from being accessed by other
users. If you do not wish to change the current password, you can leave New Password and
Confirm New Password blank. Click
Next
.