LTE CPE
(
ALR-U-series
)
User Manual
05/21/2015
9
Subnet Mask
- An address code that determines the size of the network.
Normally use 255.255.255.0 as the subnet mask.
DHCP
- Enable or Disable the DHCP. If you disable the DHCP function, Client
cannot get valid IP address from CPE automatically. But you can configure the
address of your PC manually to connect CPE.
Start IP Address
- Specify an IP address for the DHCP server to start with
when assigning IP address. The default start address is 192.168.0.2.
End IP Address
- Specify an IP address for the DHCP Server to end with
when assigning IP address. The default end address is 192.168.0.254.
Lease Time
- The Lease Time is the amount of time a network user will be
allowed connection to the router with their current dynamic IP address.
Enter the amount of time in minutes and the user will be "leased" this
dynamic IP address. After the time is up, the user will be assigned a new
dynamic IP address automatically.
Static IP
- IP/MAC binding function, the system will assign a fixed IP address
to the MAC according to the rules.
Note:
1.
If you change the IP Address of LAN, you must use the new IP address to login
to the CPE router.
2.
If the new LAN IP address you set is not in the same subnet, the IP address
pool of the DHCP server will change at the same time, while the Virtual Server
and DMZ Host will not take effect until they are re-configured.
3.4.1.2 WiFi Settings
Clicking on “W
iFi Settings
”
will take you to the following header and on this
page you can configure the WiFi settings and WiFi security.
WiFi Settings
You can set the WiFi status, configure the WiFi standard, configure the network
name and select the WiFi channel from 1 to 13.