Chapter 13 Interface Group
VMG4380-B10A / VMG4325-B10A User’s Guide
201
Note: An interface can belong to only one group at a time.
Figure 95
Interface Group Configuration
The following table describes the fields in this screen.
Table 70
Interface Group Configuration
LABEL
DESCRIPTION
Group Name
Enter a name to identify this group. You can enter up to 30 characters. You can use letters,
numbers, hyphens (-) and underscores (_). Spaces are not allowed.
WAN Interface
used in the
grouping
Select the WAN interface this group uses. The group can have up to one PTM interface and
up to one ATM interface.
Select
None
to not add a WAN interface to this group.
Grouped LAN
Interfaces
Available LAN
Interfaces
Select one or more LAN interfaces (Ethernet LAN, HPNA or wireless LAN) in the
Available
LAN Interfaces
list and use the left arrow to move them to the
Grouped LAN Interfaces
list to add the interfaces to this group.
To remove a LAN or wireless LAN interface from the
Grouped LAN Interfaces
, use the
right-facing arrow.
Automatically
Add Clients
With the
following DHCP
Vendor IDs
Click
Add
to identify LAN hosts to add to the interface group by criteria such as the type of
the hardware or firmware. See
Section 13.2.2 on page 202
for more information.
#
This shows the index number of the rule.
Filter Criteria
This shows the filtering criteria. The LAN interface on which the matched traffic is received
will belong to this group automatically.
WildCard
Support
This shows if wildcard on DHCP option 60 is enabled.