Page 351 / 428
Scroll up to view Page 346 - 350
Configuring Syslog Logging
Chapter 17: Maintenance
337
To configure Syslog logging
1.
Click
Setup
in the main menu, and click the
Logging
tab.
The
Logging
page appears.
2.
Complete the fields using the information in the following table.
3.
Click
Apply
.
Table 80: Logging Page Fields
In this field…
Do this…
Syslog Server
Type the IP address of the computer that will run the Syslog service
(one of your network computers), or click
This Computer
to allow your
computer to host the service.
Clear
Click to clear the
Syslog Server
field.
Syslog Port
Type the port number of the Syslog server.
Default
Click to reset the
Syslog Port
field to the default (port 514 UDP).
Page 352 / 428
Configuring HTTPS
338
Check Point ZoneAlarm User Guide
Configuring HTTPS
You can enable ZoneAlarm router users to access the ZoneAlarm Portal from the Internet.
To do so, you must first configure HTTPS.
Note:
Configuring HTTPS is equivalent to creating a simple Allow rule, where the
destination is
This Gateway
. To create more complex rules for HTTPS, such as
allowing HTTPS connections from multiple IP address ranges, define Allow rules for
TCP port 443, with the destination
This Gateway
. For information, see
Using Rules
on page 172.
To configure HTTPS
1.
Click
Setup
in the main menu, and click the
Management
tab.
The
Management
page appears.
2.
Specify from where HTTPS access to the ZoneAlarm Portal should be granted.
See
Access Options
on page 340 for information.
Warning:
If remote HTTPS is enabled, your ZoneAlarm router settings can be
changed remotely, so it is especially important to make sure all ZoneAlarm router
users’ passwords are difficult to guess.
Page 353 / 428
Configuring HTTPS
Chapter 17: Maintenance
339
Note:
You can use HTTPS to access the ZoneAlarm Portal from your internal
network, by surfing to https
:
//my.firewall.
If you selected
Internal Networks + IP Range
, additional fields appear.
3.
If you selected
Internal Networks + IP Range
, enter the desired IP address range
in the fields provided.
4.
Click
Apply
.
The HTTPS configuration is saved. If you configured remote HTTPS, you can now
access the ZoneAlarm Portal through the Internet, using the procedure
Accessing the
ZoneAlarm Portal Remotely
on page 47.
Page 354 / 428
Configuring HTTPS
340
Check Point ZoneAlarm User Guide
Table 81: Access Options
Select this
option…
To allow access from…
Internal Networks
The internal network only.
This disables remote access capability. This is the default.
Internal Networks +
VPN
The internal network and your VPN.
Internal Networks +
IP Range
A particular range of IP addresses.
Additional fields appear, in which you can enter the desired IP address
range.
ANY
Any IP address.
Disabled
Nowhere. Access via this protocol is disabled.
This option is relevant to the SNMP protocol only.
Page 355 / 428
Setting the Time on the Router
Chapter 17: Maintenance
341
Setting the Time on the Router
You set the time displayed in the ZoneAlarm Portal during initial router setup. If desired,
you can change the date and time using the procedure below.
To set the time
1.
Click
Setup
in the main menu, and click the
Tools
tab.
The
Tools
page appears.
2.
Click
Set Time
.
The
ZoneAlarm Set Time Wizard
opens displaying the
Set the ZoneAlarm Time
dialog
box.
3.
Complete the fields using the information in
Set Time Wizard Fields
on page
343.
4.
Click
Next.
19216811.live