Page 51 / 58 Scroll up to view Page 46 - 50
Connect to network
zNID Hardware Installation Guide
51
Connecting coaxial port
The zNID-24xx series models have a coaxial port for RF video. The RF signal
is 46 MHz to 870 MHz
Connect coaxial port
The zNID provides a coaxial port for RF Video.
1
Locate the coaxial cable.
2
Screw the coaxial connector into the
coaxial connector
.
Figure 18:
The coaxial port.
Page 52 / 58
zNID 24xx Installation
52
zNID Hardware Installation Guide
Connecting USB port
The zNID-24xx series models have a USB 2.0 port for future applications.
Figure 19:
The USB port.
Complete the zNID installation
After making the physical connections, complete the installation by checking
the LEDs, the grounding for the full enclosure, closing the outer cover, sealing
the entry holes, and screwing in the final screw to secure the unit.
Checking the LEDs
Check the LEDs to verify that power is working.
See the
zNID 24xx series LEDs
on page 29
.
Page 53 / 58
zNID Hardware Installation Guide
53
A
PPENDIX
: P
INOUTS
This appendix provides the following pinouts
Gigabit Ethernet pinouts
on page 53
POTS pinouts
on page 54
UPS pinouts
on page 55
Gigabit Ethernet pinouts
Figure 20:
The Gigabit Ethernet ports use an RJ45 connector
Table 7:
Pinout for the GigE RJ45
Pin
Name
Description
1
TX_D1+
Transceive data +
2
TX_D1-
Transceive data -
3
RX_D2+
Recieve data +
4
BI_D3+
Bi-directional data +
5
BI_D3-
Bi-directional data -
6
RX_D2-
Receive data -
7
BI_D4+
Bi-directional data +
8
BI_D4-
Bi-directional data -
Page 54 / 58
Appendix: Pinouts
54
zNID Hardware Installation Guide
POTS pinouts
Figure 21:
The POTS ports use an RJ11 connector
Table 8:
Pinout for the POTS RJ11
Pin
Description
1
N/C
2
N/C
3
Ring
4
Tip
5
N/C
6
N/C
Page 55 / 58
UPS pinouts
zNID Hardware Installation Guide
55
UPS pinouts
Figure 22:
Pin out layout for the UPS connector
Table 9:
Pin out descriptions for the UPS connection
Pin
Signal
Comments
1
+12V
UPS in
2
GND
UPS return. Connected to Signal GND on ONT
3
On battery
Open signal when on battery power
4
Signal return
Connected to Signal GND on ONT
5
Missing battery
Open signal when battery not detected
6
Replace battery
Open signal when battery should be replaced
7
GND
Connected to Signal GND on ONT
8
Low Battery
Open signal when battery is low

Rate

4 / 5 based on 3 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top