Page 61 / 117
Scroll up to view Page 56 - 60
15xx-A1 Family Router Users Guide
61
3.
From the
Queue Config
page, click
Add
.
4.
In the
QoS Queue Configuration
page enter the name of the queue and enable the queue
by selecting
Enable
from the
Queue Configuration Status
drop down.
5.
Select the interface from the
Interface
drop down.
6.
Set the priority for the queue from the
Precedence
drop down
7.
Click
Save/Apply
.
Page 62 / 117
15xx-A1 Family Router Users Guide
62
QoS Classification
You can configure the Quality of Service to apply different priorities to traffic on the router.
The
Add Network Traffic Class Rule
screen allows you to add a network traffic class rule.
To add a rule:
1.
In the
Quality of Service
—
QoS Classification
screen, click
Add
.
2.
In the
Add Network Traffic Class Rule
screen give a name to this traffic class.
3.
Assign a priority level
—
low, medium, and high
—
to this traffic class.
Page 63 / 117
15xx-A1 Family Router Users Guide
63
4.
Select an IP precedence from the 0-7 range.
5.
Enter an IP Type of Service from the following selections
—
Normal Service
Minimize Cost
Maximize Reliability
Maximize Throughput
Minimize Delay
6.
Enter the traffic conditions for the class such as the protocol (TCP / UDP, TCP, UDP, or
ICMP) to be used.
7.
Click
Save / Apply
to save the settings.
Routing
Under the Routing heading you assign a default gateway, create a routing table (in Static Route),
create routing policy rules, and activate Routing Information Protocol (RIP) on the device.
Default Gateway
You can enable an automatic assigned default gateway on the
Routing
–
Default Gateway
screen or specify a static default gateway. By default, the
Enable Automatic Assigned Default
Gateway
checkbox is checked.
To enable
Automatic Assigned Default Gateway
leave the checkbox checked. To disable
Automatic Assigned Default Gateway
uncheck the checkbox.
Page 64 / 117
15xx-A1 Family Router Users Guide
64
If you change the automatic assigned default gateway address, you must reboot the router to be
assigned a new default gateway IP address.
Static Route
To add a routing table use the
Static Route
page. A maximum of 32 entries can be configured.
1.
Click
Add
.
2.
Enter the route information and then click
Apply/Save
.
Page 65 / 117
15xx-A1 Family Router Users Guide
65
Policy Route
The policy routing feature allows the administrator to have more control over how packets should
flow through the modem and into their networks. The feature allows administrator to route IP
packets according to their Source Interface; Source/Destination IP address/subnets; IP Protocols;
Source/Destination Ports to specific Gateway address and/or Gateway Interfaces.
To add a policy routing rule:
1.
Click
Add
.
19216811.live