1. Home
    2. /
  2. Manuals
    3. /
  3. Westell
    4. /
  4. VersaLink-B90-755025-15
    5. /
  5. 17
Page 81 / 126 Scroll up to view Page 76 - 80
030-300613 Rev A
81
August 2009
User Guide
VersaLink Wireless Gateway (Model 7500)
14.2.3.3
DSL Transceiver
The following screen will appear if you select
Advanced > Diagnostics > Network Statistics > DSL Transceiver
from the main menu. This screen displays information about your Gateway’s DSL transceiver.
NOTE:
If your Gateway’s Ethernet VersaPort is configured for “WAN Uplink Port” instead of “LAN Ethernet
Port,” this feature will not be available. Refer to section 14.4.3, “VersaPort.”
Transceiver Revision
Displays the transceiver software version number.
Vendor ID Code
Displays the CPE vendor’s chipset ID code.
Line Mode
Displays the operational mode: ADSL2, Annexl, ADSL_ANSI_T1.413,
ADSL_G.dmt, ADSL_G.lite, ADSL_2plus, and ADSL_re-adsl.
Data Path
Displays the data path used (either Fast or Interleaved).
Transceiver Information-Downstream Path/Upstream Path
DSL Speed (Kbits/Sec)
Displays the transmission rate provided by your ISP.
Margin (db)
Displays the Signal-to-Noise Ratio (S/N), where 0 db = 1x10
-7
, which inhibits
your DSL speed.
Line Attenuation (dB)
Displays DSL line loss.
Transmit Power (db/Hz)
Displays transmitted signal strength.
Page 82 / 126
030-300613 Rev A
82
August 2009
User Guide
VersaLink Wireless Gateway (Model 7500)
14.2.3.4
WAN VC
The following screen will appear if you select
Advanced > Diagnostics > Network Statistics > WAN VC
from the
main menu. This screen displays information about your Gateway’s WAN virtual connection (VC) settings.
NOTE:
If your Gateway’s Ethernet VersaPort is configured for “WAN Uplink Port” instead of “LAN Ethernet
Port,” this feature will not be available. Refer to section 14.4.3, “VersaPort.”
VPI/VCI
Displays the VPI/VCI values obtained from your ISP.
In Errors
Displays the number of error packets received on the ATM port. “In” is from the PC
to the remote.
In Discard Packets
Displays the number of discarded packets received. “In” is from the PC to the
remote.
In Unicast Packets
Displays the number of Unicast packets received on the ATM port. “In” is from the
PC to the remote.
In Octets
Displays the number of bytes received on the ATM port. “In” is from the PC to the
remote.
Out Errors
Displays the number of outbound packets that could not be transmitted due to errors.
“Out” is from the remote to the PC.
Out Discard Packets
Displays the number of outbound packet discarded. “Out” is from the remote to the
PC.
Out Unicast Packets
Displays the number of Unicast packets transmitted on the ATM port. “Out” is from
the remote to the PC.
Out Octets
Displays the number of bytes transmitted on the ATM port. “Out” is from the remote
to the PC.
Page 83 / 126
030-300613 Rev A
83
August 2009
User Guide
VersaLink Wireless Gateway (Model 7500)
14.2.3.5
USB
The following screen will appear if you select
Advanced > Diagnostics > Network Statistics > USB
from the main
menu. This screen displays information about your Gateway’s USB connection.
Number of Resets
Displays the number of times the Host PC reset the USB Interface.
Number of Isrs
Displays the number of times the Host PC requested communication with the
Gateway.
In Unicast Packets
Displays the number of packets received that did not have a Multicast or Broadcast
class destination IP address. “In” is from the host PC to the Gateway.
In Non-Unicast Packets
Displays the number of packets received that had a Multicast or Broadcast class
destination IP address. “In” is from the host PC to the Gateway.
In Multicast Frames
Displays the number of frames received that had a Multicast class destination IP
address. “In” is from the host PC to the Gateway.
In Broadcast Frames
Displays the number of frames received that had a Broadcast class destination IP
address. “In” is from the host PC to the Gateway.
In Errors
Displays the number of packets received with an invalid format. “In” is from the host
PC to the Gateway.
Out Good Frames
Displays the number of frames sent to the Host PC. “Out” is from the Gateway to the
host PC.
Out Unicast Packets
Displays the number of packets sent that did not have a Multicast or Broadcast class
destination IP address. “Out” is from the Gateway to the host PC.
Out Non-Unicast Packets
Displays the number of packets sent that had a Multicast or Broadcast class
destination IP address. “Out” is from the Gateway to the host PC.
Out Multicast Frames
Displays the number of frames sent that had a Multicast class destination IP address.
“Out” is from the Gateway to the host PC.
Out Broadcast Frames
Displays the number of frames sent that had a Broadcast class destination IP address.
“Out” is from the Gateway to the host PC.
Out Errors
Displays the number of packets received by the Gateway but not sent to PC due to an
Error condition. “Out” is from the Gateway to the host PC.
Page 84 / 126
030-300613 Rev A
84
August 2009
User Guide
VersaLink Wireless Gateway (Model 7500)
14.2.3.6
Wireless
The following screen will appear if you select
Advanced > Diagnostics > Network Statistics > Wireless
from the
main menu. This screen displays information about your Gateway’s wireless connection.
Network Name (SSID)
Displays a string of 32 characters or less, which is the name
associated with the Access Point (AP). To connect to the Gateway,
the Service Set ID (SSID) on a Station card must match the SSID on
the Gateway.
802.11 MAC Address (BSSID)
Displays the Media Access Controller address of the AP. It is used as
the Basic Service Set Identifier (BSSID).
FW Version
Displays the Network Interface Card Identifier. It uniquely identifies
the hardware platform of the AP. This is used with other information
to determine if the inserted card can be used as a modem, and if so,
the version of modem firmware to be used. Not all makes of wireless
station cards can be used as a modem.
Communication Statistics
OUT-Unicast Frames
Displays the number of successfully transmitted frames whose
destination address was a single station, not necessarily the same
station, but to any single station. This is as opposed to a transmission
that multiple stations would receive, as in the case of broadcast
messages. “Out” is from the Gateway to the host PC.
OUT-Multicast Frames
Displays the number of successfully transmitted frames whose
destination address was a multicast address (received by more that
one station), not necessarily broadcast to all stations, but more than a
single station. Broadcast messages are included in the count. “Out” is
from the Gateway to the host PC.
OUT-Dropped Frames
Displays the number of frames that did not transmit due to the short
or long retry limit being reached as a result of no acknowledgement or
CTS received. “Out” is from the Gateway to the host PC.
OUT-Packets
Displays the total number of packets sent. “Out” is from the Gateway
to the host PC.
OUT-Bytes
Displays the total number of bytes sent. “Out” is from the Gateway to
the host PC.
Page 85 / 126
030-300613 Rev A
85
August 2009
User Guide
VersaLink Wireless Gateway (Model 7500)
OUT-Errors
Number of packets sent with error. “Out” is from the Gateway to the
host PC.
IN-Unicast Frames
Displays the number of successfully received frames whose
destination address was a single location, not necessarily the same
location, but to any single location as opposed to the broadcast
address. “In” is from the host PC to the Gateway.
IN-Multicast Frames
Displays the number of successfully received frames whose
destination address was a multicast address. Broadcast messages are
included in this count. “In” is from the host PC to the Gateway.
IN-Dropped Frames
Displays the number of received frames which are invalid or cannot
be passed on. “In” is from the host PC to the Gateway.
IN-Packets
Displays the total number of packets received. “In” is from the host
PC to the Gateway.
IN-Bytes
Displays the total number of bytes received. “In” is from the host PC
to the Gateway.
IN-Errors
Displays the number of packets received with error. “In” is from the
host PC to the Gateway.
14.2.4
System Status Tables
This section discusses the
System Status Tables
screens (LAN Devices, Wireless Stations, RIP Tables, and QoS) of
your Gateway and guides you through the configurable settings.

Rate

4.5 / 5 based on 2 votes.

Popular Westell Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top