Page 16 / 96 Scroll up to view Page 11 - 15
12
Remove the 4G LTE SIM Card
To remove the 4G LTE SIM card, follow these steps:
Remove the battery cover located on the underside of the Jetpack.
Remove the battery from the back of the Jetpack by inserting your fingernail into the battery
removal divot and lifting the battery out of the battery compartment.
Lift the SIM card removal hinge and move out of the way.
Place your forefinger on the SIM Card and carefully slide the SIM Card backwards to remove.
Replace the SIM card removal hinge and snap into place.
NOTE
Should your 4G SIM card be lost or damaged, contact your network operator.
Page 17 / 96
13
Insert and Charge the Battery
IMPORTANT
Before you use your Jetpack, be sure to charge the battery for at least 3.5 hours
to ensure a full initial charge.
To insert and charge the battery, follow these steps:
Press your finger against the battery removal tab, then lift and remove the cover.
Align the gold-colored contacts on the battery with the gold-colored contacts on the
Jetpack and gently slide the battery into place.
Replace the cover by setting it on the Jetpack where the notches align, then press on the
cover until it clicks into place and is flat across the entire bottom surface.
Page 18 / 96
14
Connect the micro USB end of the charger into the charging port of the Jetpack.
Plug the other end of the wall charger into the appropriate electrical outlet.
CAUTION!
Use only batteries and chargers with your Jetpack that have been approved by
Verizon Wireless. The failure to use approved batteries and chargers may increase the risk that
your Jetpack will overheat, catch fire, or explode, resulting in serious bodily injury, death, or
property damage.
Battery Removal
To remove or replace the battery, follow these steps:
Press your finger against the battery door removal tab, then lift and remove the battery
cover. Set the cover aside.
Insert your finger into the battery removal divot and lift the battery out of the battery
compartment.
Page 19 / 96
15
Battery Tips
WARNING !
Always use only approved batteries and chargers with your Jetpack. The warranty
does not cover damage caused by non-approved batteries and/or chargers.
It normally takes at least three hours to fully charge the battery with the wall charger.
Do not use sharp objects to access the battery well, this may damage the Jetpack and the
battery.
Do not use excessive force to remove the battery or to access the battery well.
The battery discharges more rapidly as additional devices access your Jetpack.
Battery life depends on the network, signal strength, temperature, features, and accessories
you use.
New batteries or batteries stored for a long time may take more time to charge.
When charging your battery, keep it near room temperature.
When storing your battery, keep it uncharged in a cool, dark, dry place.
Never expose batteries to temperatures below -20°C (4°F) or above 60°C (140°F).
Never leave the Jetpack in an unattended vehicle due to uncontrollable temperatures that
may be outside the desired temperature for this Jetpack.
Some batteries perform best after several full charge/discharge cycles.
It is normal for batteries to gradually wear down and require longer charging times. If you
notice a change in your battery life, it is probably time to purchase a new battery.
IMPORTANT
Whenever you remove or insert either the battery or the SIM card, ensure your
MiFi Jetpack is not connected to any device or power source. Never use tools, knives, keys, pens
or any type of object to force the door open or to remove the battery. Using any of these types of
objects could result in puncturing the battery.
WARNING !
The failure to use approved batteries and chargers may increase the risk that your
Jetpack will overheat, catch fire, or explode, resulting in serious bodily injury, death, or property
damage. To avoid risk of explosion, never dispose of batteries in a fire.
Page 20 / 96
16
Power the Jetpack On and Off
Power On
Press the Power Button until the Jetpack display lights up. After the initial startup screens
display,
select
Menu
to access the menu.
Power Off
Press and hold the Power Button until the display shows
MiFi Powering Off
. The Jetpack will
continue its shutdown procedures for several seconds and then automatically turn off the
display.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top