802.11
MODE
2.
To enable access control, select the
Enable Access List
check
box.
3.
Select either:
•
Accept all devices listed below
– allows only the listed
devices to access the wireless network.
Warning:
This will block wireless network access for all devices
not in the list. Only devices in the list will be able to connect to
the wireless network.
•
Deny all devices listed below
– denies access to the listed
devices. All other wireless devices will be able to access
the wireless network if they use the correct wireless
password.
4.
Enter the MAC address of a device, then click
Add
.
5.
Repeat step 2 to add additional devices, as needed.
6.
To remove a specific device’s MAC address, click the
Remove
button next to the specific MAC address.
7.
When all changes are complete, click
Apply
to save changes.
3.5/
802.11 MODE
From the 802.11 Mode page, you can limit the wireless access to your
network by selecting the 2.4 GHz and 5 GHz wireless communication
standard (mode) best suited or compatible with the devices you allow
access to your wireless network.
19216811.live