Given below is full router user manual of TRENDnet TEW-430APBv3 router model. You can also download this manual in PDF Format to read later on your computer.
Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.
Page 2 / 11
Table of Contents
Version 09.27.2007
English
......................................................................................................
Troubleshooting
........................................................................................
1
1
2
3
6
1. Before You Start
2. Install Hardware
.................................................................................
3. Configure the Access Point
................................................................
.................................................................................
Page 3 / 11
Installation Requirements
Application
Web Browser: Internet Explorer (5.5 or higher) or
Netscape Navigator (4.7 or higher).
A computer with a network adapter properly installed.
A network Switch or Hub with an available network LAN port.
A RJ-45 network cable.
Package Content
1. Before You Start
English
1
Workstation with
Wireless PCI Adapter
(TEW-423PI)
Notebook with
Wireless PC Card
(TEW-421PC)
Cable/DSL 4-Port
Firewall Router
(TW100-BRF114
)
Workstation with
PCI Adapter
(TE100-PCIWN)
54Mbps 802.11g Wireless LAN Access Point
(TEW-430APB)
Cable/DSL
Modem
Internet
TEW-430APB
Quick Installation Guide
User’s Guide CD-ROM
External Power Adapter
1 x 2dBi Detachable Antenna
Page 4 / 11
3.
Verify that the following front panel
lights are on:
WLAN
and
LAN
.
2. Hardware Installation
English
2
2.
Connect the Power Adapter to the
Access Point and then to a power
outlet.
Note: Locate an optimum location for the Access Point. The best place for the
Access Point is usually at the center of your wireless network. Please connect
the computer configuring the TEW-430APB to the same switch/hub.
1.
Connect a RJ-45 cable from the
Switch/Hub to the
LAN
port of the
Access Point and then connect the
2dBi Detachable Antenna.
Page 5 / 11
English
3
3. Configure the Access Point
Note: It is recommended that you configure the Access Point from a wired
computer.
Before the Access Point can be configured, a Static IP address
must be assigned to your computer's network adapter in the subnet of
192.168.1.x.
make sure no other network devices are assigned an IP address of
192.168.1.100.
(Refer to the Troubleshooting section on how to configure
TCP/IP settings on your PC)
2.
Enter User name and Password,
and then click
OK
. By default,
User name:
admin
Password:
admin
1.
Open your web browser, type
in the
Address bar, and press
Enter
.
3.
Click
Wizard
.
19216811.live