Page 11 / 118
Scroll up to view Page 6 - 10
-7-
z
AC Power Receptacle
Connect the female connector of the power cord to this power receptacle, and the male connector to the
AC power outlet. Please make sure the voltage of the power supply meets the requirement of the input
voltage (100-240V~ 50/60Hz).
z
Reset button
Use the button to restore the Router to the factory defaults. With the Router powered on, use a pin to
press and hold the Reset button (about 5 seconds). If the SYS LED is flashing 5 times in high frequency,
release the Reset button. It means the Router is restored successfully. The default management
address of the Router is
, and the default username and the password are both
admin
.
z
Interface Description
Interface
Port
Description
WAN
1~4
The WAN port is for connecting the Router to a DSL/Cable
modem or Ethernet by the RJ45 cable.
LAN
2~5
The LAN port is for connecting the Router to the local PCs or
switches by the RJ45 cable.
Note:
Please only use the power cord provided with this Router.
Page 12 / 118
-8-
Chapter 3 Quick Installation Guide
After connecting the TL-R470T+ router into your network, you should configure it. This chapter
describes how to configure the basic functions of your TL-R470T+ Load Balance Broadband Router.
These procedures only take you a few minutes. You can access the Internet via the router immediately
after it has been successfully configured.
3.1 Configure PC
Step 1:
Click the
Start
menu on your desktop, right click
My Network Places
, and then select
Properties
(shown in Figure 3-1).
Figure 3-1
Page 13 / 118
-9-
Step 2:
In the next screen, right click
Local Area Connection
(LAN), and then select
Properties
.
Figure 3-2
Step 3:
In the next screen, select
General
tab, highlight Internet Protocol (TCP/IP), and then click the
Properties
button.
Figure 3-3
Page 14 / 118
-10-
Step 4:
Configure the IP address as shown in Figure 3-4. After that, click
OK
.
Figure 3-4
Note:
You can configure the PC to get an IP address automatically, select “
Obtain an IP address
automatically
” and “
Obtain DNS server address automatically
” in the screen above. For Windows
98 OS or earlier, the PC and router may need to be restarted.
Now, you can run the Ping command in the command prompt to verify the network connection. Please
click the
Start
menu on your desktop, select
run
tab, type
cmd
in the field, and then type
ping
192.168.0.1
on the next screen, and then press
Enter
.
If the result displayed is similar to the screen below, the connection between your PC and the Router
has been established.
Figure 3-5
If the result displayed is similar to the screen shown below, it means that your PC has not connected to
the Router.
Page 15 / 118
-11-
Figure 3-6
You can check it by following the steps below:
Note:
●
Is the connection between your PC and the Router correct?
The LEDs of LAN port which you link to the device and the LEDs on your PC's adapter should be lit.
●
Is the TCP/IP configuration for your PC correct?
If the Router's IP address is
192.168.0.1, your PC's IP address must be within the range of
192.168.0.2 ~ 192.168.0.254, the gateway must be
192.168.0.1.
3.2 Login
Once your host PC is properly configured, please proceed as follows to use the Web-based Utility:
Start your web browser and type the private IP address of the Router in the URL field:
.
After that, you will see the screen shown below; enter the default User Name
admin
and the default
Password
admin
.
19216811.live