Page 26 / 125
Scroll up to view Page 21 - 25
TD-W9970
300Mbps Wireless N USB VDSL/ADSL Modem Router User Guide
15
Chapter 4. Configuring the Modem Router
This chapter will show each Web page's key function and the configuration.
4.1 Login
After your successful login, you will see the twenty-two main menus on the left of the Web-based
management page. On the right, there are the corresponding explanations and instructions.
The detailed explanations for each Web page’s key function are listed below.
4.2 Status
Choose “
Status
”, you can see the corresponding information about
Device Information
,
DSL
,
WAN
,
LAN
and
Wireless
.
Page 27 / 125
TD-W9970
300Mbps Wireless N USB VDSL/ADSL Modem Router User Guide
16
Figure 4-1
Page 28 / 125
TD-W9970
300Mbps Wireless N USB VDSL/ADSL Modem Router User Guide
17
4.3 Quick Setup
Please refer to Section
3.2 Quick Installation Guide
.
4.4 Operation Mode
Choose “
Operation Mode
”, and you will see the screen as shown in Figure 4-2. Select your
desired mode and then click
Save
.
Figure 4-2
DSL Modem Router Mode:
In this mode, the device enables multi-users to share Internet via
ADSL/VDSL using its VDSL port and share it wirelessly at 300Mbps wireless 802.11n speeds.
3G/4G Router Mode:
In
this mode, the device
allows multi-users to share a 3G/4G mobile
broadband connection via wired or wireless connection.
Wireless Router Mode:
In this mode, the device enables multi-users to share Internet via
Ethernet WAN (EWAN) using its interchangeable LAN/WAN port and share it wirelessly at
300Mbps wireless 802.11n speeds.
After you click the
Save
button, the Note Dialog will appear. Click
OK
and then the modem router
will reboot. Please wait.
Note Dialog
4.5
Network
Choose “
Network
”, there are many submenus under the main menu. Click any one of them, and
you will be able to configure the corresponding function.
Page 29 / 125
TD-W9970
300Mbps Wireless N USB VDSL/ADSL Modem Router User Guide
18
4.5.1 WAN Settings
Choose “
Network
”
“
WAN Settings
”, and you will see the WAN Port Information Table in the
screen similar to Figure 4-3.
4.5.1.1 VDSL WAN Settings
For
VDSL
mode, there are four different connection types, which are Static IP, Dynamic IP,
PPPoE and Bridge. You can select the corresponding types according to your needs.
Figure 4-3
Click
Add
to add a new entry, you can configure the parameters for PTM and WAN Service in the
next screen (shown in Figure 4-4).
Page 30 / 125
TD-W9970
300Mbps Wireless N USB VDSL/ADSL Modem Router User Guide
19
Figure 4-4
DSL Modulation Type:
DSL Modulation Type:
The modem router supports two modulation types: ADSL and VDSL,
you can select the corresponding types according to your needs.
PTM Configuration:
Enable VLAN ID:
Check the box to enable the Virtual LAN ID.
VLAN ID (1~4049):
This indicates the VLAN group, and the valid range is from 1 to 4049.
1) Static IP
Select this option if your ISP provides static IP information to you. You should set static IP address,
IP subnet mask, and gateway address in the screen below.
19216811.live