Page 16 / 87 Scroll up to view Page 11 - 15
TD-W8961ND
300Mbps Wireless N ADSL2+ Modem Router User Guide
8
Figure 2-3
Downloaded from
www.Manualslib.com
manuals search engine
Page 17 / 87
TD-W8961ND
300Mbps Wireless N ADSL2+ Modem Router User Guide
9
Chapter 3
Quick Installation Guide
3.1
Configure PC
After you directly connect your PC to the TD-W8961ND or connect your adapter to a Hub/Switch
which has connected to the Router, you need to configure your PC’s IP address. Follow the steps
below to configure it..
Step 1:
Click the
Start
menu on your desktop, right click
My Network Places
, and then select
Properties
(shown in Figure 3-1).
Figure 3-1
Step 2:
Right click
Local Area Connection
(LAN), and then select
Properties
.
Downloaded from
www.Manualslib.com
manuals search engine
Page 18 / 87
TD-W8961ND
300Mbps Wireless N ADSL2+ Modem Router User Guide
10
Figure 3-2
Step 3:
Select
General
tab, highlight Internet Protocol (TCP/IP), and then click the
Properties
button.
Figure 3-3
Downloaded from
www.Manualslib.com
manuals search engine
Page 19 / 87
TD-W8961ND
300Mbps Wireless N ADSL2+ Modem Router User Guide
11
Step 4:
Configure the IP address as Figure 3-4 shows. After that, click
OK
.
Figure 3-4
)
Note:
You can c
onfigure the PC to get an IP address automatically, select “Obtain an IP address
automatically” and “Obtain DNS server address automatically” in the screen above.
Now, you can run the Ping command in the command prompt to verify the network connection.
Please click the
Start
menu on your desktop, select
run
tab, type
cmd
or
command
in the field
and press
Enter
. Type
on the next screen, and then press
Enter
.
If the result displayed is similar to the screen below, the connection between your PC and the
Router has been established.
Figure 3-5
Downloaded from
www.Manualslib.com
manuals search engine
Page 20 / 87
TD-W8961ND
300Mbps Wireless N ADSL2+ Modem Router User Guide
12
If the result displayed is similar to the screen shown below, it means that your PC has not
connected to the Router.
Figure 3-6
You can check it follow the steps below:
1)
Is the connection between your PC and the Router correct?
The LEDs of LAN port which you link to the device and the LEDs on your PC's adapter should
be lit.
2)
Is the TCP/IP configuration for your PC correct?
If the Router's IP address is 192.168.1.1, your PC's IP address must be within the range of
192.168.1.2 ~ 192.168.1.254.
3.2
Login
Once your host PC is properly configured, please proceed as follows to use the Web-based Utility:
Start your web browser and type the private IP address of the Router in the URL field:
192.168.1.1
.
After that, you will see the screen shown below, enter the default User Name
admin
and the
default Password
admin
,
and then click
OK
to access to the
Quick Start
screen. You can follow
the steps below to complete the Quick Start.
Figure 3-7
Downloaded from
www.Manualslib.com
manuals search engine

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top