TD-VG3631

300Mbps Wireless N VoIP ADSL2+ Modem Router User Guide

17

6.

Basic parameters of Voice can be set on the

Voice

screen. Please enter a profile name to

identify this account and other parameters provided by your ISP. If you don’t want to configure

VoIP function now, leave "Profile Name" blank and click

Next

to skip.

Figure 3-13

7.

On this page, please confirm all parameters. Click

Previous

to modify or click the

Save

button to make the configuration take effect.

Figure 3-14

8.

You will see the

Complete

screen below, click

Finish

to complete these settings.

TD-VG3631

300Mbps Wireless N VoIP ADSL2+ Modem Router User Guide

18

Figure 3-15

TD-VG3631

300Mbps Wireless N VoIP ADSL2+ Modem Router User Guide

19

Chapter 4. Configuring the Modem Router

This chapter will show each Web page's key function and the configuration way.

4.1 Login

After your successful login, you will see the fifteen main menus on the left of the Web-based utility.

On the right, there are the corresponding explanations and instructions.

The detailed explanations for each Web page’s key function are listed below.

4.2 Status

Choose “

Status

”, you can see the corresponding information about

Device Information

,

DSL

,

WAN

,

LAN

WLAN

and

Voice

.

TD-VG3631

300Mbps Wireless N VoIP ADSL2+ Modem Router User Guide

20

Figure 4-1

4.3 Quick Setup

Please refer to Section

3.2 Quick Installation Guide

.

4.4 Network

Choose “

Network

”, there are many submenus under the main menu. Click any one of them, and

you will be able to configure the corresponding function.

TD-VG3631

300Mbps Wireless N VoIP ADSL2+ Modem Router User Guide

21

4.4.1 WAN Settings

Choose “

Network

”

Æ

“

WAN Settings

”, and you will see the WAN Port Information Table in the

screen similar to Figure 4-2, which describes the WAN port settings and the relevant manipulation

to each interface. There are five different configurations for the connection types, which are Static

IP, Dynamic IP, PPPoE, IPoA, and Bridge. You can select the corresponding types according to

your needs.

Figure 4-2

Click

Add

to add a new entry, you can configure the parameters for ATM and WAN Service in the

next screen (shown in Figure 4-3).