Page 11 / 78
Scroll up to view Page 6 - 10
TD-8811
ADSL2+ Modem Router User Guide
6
2.2
Rear-panel
¾
ON/OFF
: Turn on/off the ADSL Router’s power.
¾
POWER
: Please use the provided power adaptor, otherwise may cause damage to the
ADSL Router.
¾
RESET (reset default)
: Press the
RESET
button and hold for five seconds and then wait
for the router to reboot to its factory default settings.
¾
LAN
: Connect to your computer with RJ45 cable.
¾
USB
: Connect with your computer’s USB interface.
¾
LINE (WAN)
: Connect to the MODEM Port of Splitter or Connect with the telephone line.
2.3
Hardware Installation Procedures
The procedure to install the Router can be described in the following steps:
First Step
: Connect the MODEM port of Splitter with the LINE port of the TD-8811 ADSL2+
Modem Router by telephone line.
Second Step
: Connect category 5 cable with RJ45 jacks to ADSL2+ Modem Router’s LAN port
and your computer’s NIC. Or connect USB cable to ADSL2+ Modem Router’s USB port and
your computer’s USB interface.
Third Step
: Plug one end of the AC Power Adapter into the Power jack on the Ethernet
ADSL2+ Modem Router and the other end to a standard electrical outlet.
Last Step
: Check the line connection to see if everything is ready. Power up finally.
Page 12 / 78
TD-8811
ADSL2+ Modem Router User Guide
7
Figure 2-1
Page 13 / 78
TD-8811
ADSL2+ Modem Router User Guide
8
Chapter 3. Quick Installation Guide
3.1
Computer Configuration
After you directly connect your PC to the TD-8811 or connect your adapter to a Hub/Switch
which has connected to the Router, you need to configure your PC’s IP address. Now you have
two ways to configure the TCP/IP protocol below:
¾
Setting IP address automatically
Step 1:
Click the
Start
menu on your desktop, right click
My Network Places
, and then select
Properties
(shown in Figure 3-1).
Figure 3-1
Step 2:
Right click
Local Area Connection
(LAN), and then select
Properties
.
Page 14 / 78
TD-8811
ADSL2+ Modem Router User Guide
9
Figure 3-2
Step 3:
Select
General
tab, highlight Internet Protocol (TCP/IP), and then click the
Properties
button.
Figure 3-3
Page 15 / 78
TD-8811
ADSL2+ Modem Router User Guide
10
Step 4:
Select “Obtain an IP address automatically” and “Obtain DNS server address
automatically” in the screen below. And then click
OK
.
Figure 3-4
¾
Setting IP address manually
The default IP address of the ADSL2+ Modem Router is
192.168.1.1, and the default Subnet
Mask is 255.255.255.0. These values can be seen from the LAN, and can be changed as your
desire. As an example, we use the default values for description in this guide.
Step 1:
Select
Use the following IP address
radio button in the next screen.
Step 2:
Enter the IP address as 192.168.1.* (* is any value between 2 to 254). The
Subnet
mask
is 255.255.255.0. Then type the ADSL Router’s LAN IP address
192.168.1.1 into
the
Default gateway
field.
Step 3:
Select
Use the following DNS server addresses
radio button. In the
Preferred
DNS
Server
field you can enter the same value as the
Default gateway
or type the local DNS
server IP address.
19216811.live