Page 26 / 124
Scroll up to view Page 21 - 25
Archer
D7
AC1750 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
15
Figure 3-13
The basic settings for your modem router are completed. Please open the web browser and try to
Page 27 / 124
Archer
D7
AC1750 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
16
Chapter 4. Configuring the Modem Router
This chapter will show each Web page's key function and the configuration way.
4.1 Login
After your successful login, you will see the twenty-three main menus on the left of the Web-based
utility. On the right, there are the corresponding explanations and instructions.
The detailed explanations for each Web page’s key function are listed below.
4.2 Status
Choose “
Status
”, you can see the corresponding information about
Device Information
,
DSL
,
WAN
,
LAN
and
Wireless
.
Page 28 / 124
Archer
D7
AC1750 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
17
Figure 4-1
4.3 Quick Setup
Please refer to Section
3.2 Quick Installation Guide
.
Page 29 / 124
Archer
D7
AC1750 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
18
4.4 Operation Mode
Choose “
Operation Mode
”, and you will see the screen as shown in Figure 4-2. Select your
desired mode and then click
Save
.
Figure 4-2
DSL Modem Router Mode:
The device enables multi-users to share Internet via ADSL using
its ADSL port and share it wirelessly at 1300Mbps wireless speeds over the crystal clear 5GHz
band and 450Mbps over the 2.4GHz band.
Wireless Router Mode:
The device enables multi-users to share Internet via Ethernet WAN
(EWAN) using its interchangeable LAN4/WAN port and share it wirelessly at 1300Mbps
wireless speeds over the crystal clear 5GHz band and 450Mbps over the 2.4GHz band.
After you click the
Save
button, the Note Dialog will appear. Click
OK
and then the modem router
will reboot. Please wait.
Note Dialog
4.5 Network
Choose “
Network
”, there are many submenus under the main menu. Click any one of them, and
you will be able to configure the corresponding function.
Page 30 / 124
Archer
D7
AC1750 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
19
4.5.1 WAN Settings
Choose “
Network
”
“
WAN Settings
”, and you will see the WAN Port Information Table in the
screen similar to Figure 4-3, which describes the WAN port settings and the relevant manipulation
to each interface. There are six different configurations for the connection types, which are Static
IP, Dynamic IP, PPPoE, PPPoA, IPoA and Bridge. You can select the corresponding types
according to your needs.
Figure 4-3
Click
Add
to add a new entry, you can configure the parameters for ATM and WAN Service in the
next screen (shown in Figure 4-4).
19216811.live