TP-Link Archer C2600 Router Manual PDF (Setup & Configuration Guide)

Page 106 / 114 Scroll up to view Page 101 - 105

102

If you can find your wireless network but fail to connect, please follow the steps

below:

• Authenticating problem, password mismatch:

1. Sometimes it will ask you to type in a PIN number when you connect to the wireless

network for the first time. This PIN number is different from the Wireless Password/

Network Security Key, usually you can only find it on the back of your wireless router;

2. If you cannot find the PIN or PIN failed, you may choose

Connecting using a security

key instead

, and then type in the

Wireless Password/Network Security Key

;

3. If it continues on saying

Network Security Key Mismatch

, it is suggested to confirm

the wireless password of your wireless router;

Note:

Wireless Password/Network Security Key is case sensitive.

4. Connect to wireless network.

• Windows was unable to connect to XXXX /Can not join this network/Taking longer

than usual to connect to this network:

1. Check the wireless signal strength of your network, if it is weak (1~3 bars), please

move the router closer and try again;

2. Change the wireless Channel of the router to 1,6,or 11 to reduce interference from

other networks;

3. Re-install or update the driver for your wireless adapter of the computer;

4. Connect to wireless network.

Page 107 / 114

103

Specifications

Hardware

Ethernet Ports

4 10/100/1000Mbps LAN Ports

1 10/100/1000Mbps WAN Port

USB Port

2 USB 3.0 Ports

Button

WPS Button, Reset Button, Wireless On/Off Button, LED On/Off Button, Power On/Off Button

External Power Supply

12V/4A

Dimensions (W x D x H)

10.4×7.8×1.5 in. (263.8×197.8×37.3mm)

Antenna

4 Dual Band Detachable Antennas

Wireless

Wireless Standards

IEEE 802.11ac/n/a 5GHz, IEEE 802.11b/g/n 2.4GHz

Frequency

2.4GHz

,

5GHz

Signal Rate

1733Mbps at 5GHz, 800Mbps at 2.4GHz

Transmit Power

CE: <20dBm(2.4GHz), <23dBm(5GHz)

FCC: <30dBm

Reception Sensitivity

5GHz: 11a 6Mbps: -91dBm; 11a 54Mbps: -73dBm; 11n HT20: -69dBm; 11n HT40: -67dBm;

11ac HT20: -66dBm; 11ac HT40: -61dBm; 11ac HT80: -58dBm

2.4GHz: 11g 54Mbps: -76dBm; 11n HT20: -73dBm; 11n HT40: -71dBm

Wireless Function

Enable/Disable Wireless Radio, WDS Bridge, WMM, Wireless Statistics

Wireless Security

64/128-bit WEP, WPA/WPA2, WPA-PSK/WPA-PSK2 encryptions

Software

WAN Type

Dynamic IP/Static IP/PPPoE/PPTP(Dual Access)/L2TP(Dual Access)/Bigpond

DHCP

Server, Client, DHCP Client List, Address Reservation

Quality of Service

WMM, Bandwidth Control

Port Forwarding

Virtual Server, Port Triggering, UPnP, DMZ

Dynamic DNS

DynDns, Comexe, NO-IP

VPN

PPTP, L2TP, IPSec

Access Control

Parental Control, Local Management Control, Host list, Access

Schedule, Rule Management

Firewall Security

DoS, SPI Firewall, IP Address Filter/Domain Filter, IP and MAC Address Binding

Protocols

Supports IPv4 and IPv6

USB Sharing

Supports Samba(Storage)/FTP Server/Media Server/Printer Server

Management

Access Control, Local Management, Remote Management

Guest Network

2.4GHz guest network x 1, 5GHz guest network x 1

Environment

Operating Temperature

0℃~40℃ (32℉ ~104℉)

Storage Temperature

-40℃~70℃ (-40℉ ~158℉)

Operating Humidity

10%~90% non-condensing

Storage Humidity

5%~90% non-condensing

Page 108 / 114

104

COPYRIGHT & TRADEMARKS

Specifications are subject to change without notice.

is a registered trademark

of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks

or registered trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or

used to make any derivative such as translation, transformation, or adaptation

Page 109 / 114

105

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following

measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

•

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions:

1 )

This device may not cause harmful interference.

2 )

This device must accept any interference received, including interference that

may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modifications to this equipment. Such modifications could void the

user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment. This device and its antenna must not be co-located or

operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to

only Mobile Configurations. The antennas used for this transmitter must be installed to

provide a separation distance of at least 20 cm from all persons and must not be co-

located or operating in conjunction with any other antenna or transmitter.”

Page 110 / 114

106

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio

interference, in which case the user may be required to take adequate measures.

National Restrictions

This device is intended for home and office use in all EU countries (and other countries

following the EU directive 1999/5/EC) without any limitation except for the countries

mentioned below:

Country

Restriction

Reason/remark

Bulgaria

None

General authorization required for outdoor use and public service

France

Outdoor use limited

to 10 mW e.i.r.p.

within the band

2454-2483.5 MHz

Military Radiolocation use. Refarming of the 2.4 GHz band has been

ongoing in recent years to allow current relaxed regulation. Full

implementation planned 2012

Italy

None

If used outside of own premises, general authorization is required

Luxembourg

None

General authorization required for network and service supply(not for

spectrum)

Norway

Implemented

This subsection does not apply for the geographical area within a

radius of 20 km from the centre of Ny-Ålesund

Russian Federation

None

Only for indoor applications

5150-5250 MHz

Country

Restriction

Reason/remark

Bulgaria

Not implemented

Planned

Croatia

License required

Military Radiolocation use. Refarming of the 2.4 GHz band has been

ongoing in recent years to allow current relaxed regulation. Full

implementation planned 2012

Italy

General authorization required if used outside own premises

Luxembourg

None

General authorization required for network and service supply (not for

spectrum)

Russian Federation

No info

5250-5350 MHz

Country

Restriction

Reason/remark

Bulgaria

Not implemented

Planned

Croatia

License required

Italy

General authorization required if used outside own premises

Luxembourg

None

General authorization required for network and service supply (not for

spectrum)

Russian Federation

No info

Rate

Popular TP-Link Models

Famous Router IPs

Famous Router Companies

Bookmark Our Site

Share