19216811.liveE-DOC-CTC-20080527-0004 v2.0
35
5
Telephony
Activating services on the web pages
To activate/deactivate supplementary services via the web page:
1
Browse to the
Thomson Gateway Web Interface
.
2
On the
Toolbox
menu, click
Telephony
.
3
In the
Location bar
, click
Configure
.
4
In the
Pick a task
list, click
View Telephony Services
.
5
In the
Location bar
, click
Configure
.
6
To activate/ deactivate supplementary services select/clear the check box of the supplementary service.
7
Click
Apply
.
Call Forwarding
Call Forwarding
informs you about the call forwarding parameters:
±
CFNR-timer
or Call Forwarding on No Reply timer is the time expressed in seconds after which an
incoming call is forwarded when not answered.
±
CFNR-destination
or Call Forwarding on No Reply destination is the telephone number to which a call is
forwarded when the CFNR-timer expires.
±
CFU-destination
or Call Forwarding Unconditional is the telephone number to which an incoming call is
always forwarded.
±
CFBS-destination
or Call Forwarding on Busy Subscriber is the telephone number to which an incoming
call is forwarded when your telephone is busy.
Using switching order commands
In order to use switching order commands (R or hook flash followed by a digit), certain supplementary
services have to be activated.
The following list gives an overview of the supplementary services that have to be activated in order to use
switching order commands (SOC):
±
Activate
Hold
when you want to
Action
Press
Illustration
To put an active call on hold and enable a
call set up (the dial tone is generated)
R, 2
To terminate the call on hold
R, 0
To terminate an active call and switch to
the call on hold
R, 1
C
B
A
on hold
dial tone
C
B
A
active
A presses
R2
C
B
A
active
C
B
A
active
on hold
A presses
R0
C
B
A
active
C
B
A
active
on hold
A presses
R1