Page 31 / 90
Scroll up to view Page 26 - 30
D810R ADSL2+ Router User Guide
2) Click “Next” to display the
window shown in the right
figure.
a. Authentication Method:
AUTO/PAP/CHAP/MSCHAP
. Usually, “AUTO” is
selected.
b. Dial on demand:
If you check this option,
you need to manually
enter the timeout time. If
no flow is detected when
the timeout time is up, the
device will disconnect the
network connection
automatically. And when a
flow is detected, the
device automatically
makes dial-up connection
again.
If you disable this option,
the device is always in
online status until device
power-off, connection
failure or other failures
occur.
26
Page 32 / 90
D810R ADSL2+ Router User Guide
C. PPP IP extension:
When the integrated
gateway is connected with
a computer, the IP address
obtained through the
upstream link is directly
allocated to this computer
connecting with the
device. After the PPP IP
extension is enabled, you
can enable the advanced
DMZ. At this time, you
need to enter your DMZ
host and subnet mask.
d. Use Static IP Address:
After this option is
checked, the device uses
this IP address as the WAN
IP address and does not
need to obtain it through
the upstream link.
e.
Retry PPP password on
authentication error
f.
Enable PPP debugging
mode.
27
Page 33 / 90
D810R ADSL2+ Router User Guide
3)
Click “Next” to display the
window shown in the right
figure.
a.
Enable IGMP Multicast:
IGMP agent. For example,
to enable the IPTV in the
PPPoE mode, you need to
check this option.
b.
Enabled WAN Service:
Checked by default. It is
recommended to keep this
default setting, unless you
do not need to activate
your WAN.
28
Page 34 / 90
D810R ADSL2+ Router User Guide
4)
Click “Next” to display the
window shown in the right
figure. This window shows
the
general
information
set.
5)
Click
“Save/Reboot”
to
activate your settings.
29
Page 35 / 90
D810R ADSL2+ Router User Guide
PPPoE mode
1)
Select “PPP over
Ethernet (PPPoE)”.
Encapsulation Mode:
VC/MUX
LLC/SNAP-BRIDGING
Once you select one
mode, the system
automatically changes
the encapsulation mode
into the one matching
your setting. Therefore,
it is recommended to
keep the default setting
unchanged.
30
19216811.live