36

Static Route

Click the

Add

button on the

Routing – Static Route

window to access the following window

displayed on the next page.

Enter the static routing information for an entry to the routing table.

Click the

Apply /

Save

button when you are finished.

Policy Routing

Click the

Add

button on the

Policy Routing Setting

window to access the following window

displayed on the next page.

Enter the Policy Routing information. Click the

Apply /

Save

button when you are finished.

37

RIP

To activate RIP for the device, select the

Enabled

radio button for Global RIP Mode. To

configure an individual interface, select the desired RIP version and operation, followed by

placing a check in the 'Enabled' checkbox for the interface. Click the

Save/Apply

button to

save the configuration, and to start or stop RIP based on the Global RIP mode selected.

DNS

To access the

DNS

windows, click the

DNS

button in the

Advanced Setup

directory. The

DNS

button appears when configuring WAN interface in PPPoA, PPPoE, MER or IPoA.

DNS Server

Select DNS Server Interface from available WAN interfaces OR enter static DNS server IP

addresses for the system. In ATM mode, if only single PVC with IPoA or static IPoE protocol is

configured, Static DNS server IP addresses must be entered.

DNS Server Interfaces can have multiple WAN interfaces served as system DNS servers but

only one will be used according to the priority with the first being the highest and the last one

the lowest priority if the WAN interface is connected. Priority order can be changed by

removing all and adding them back in again. Click the

Apply / Save

button when you are

finished.

38

Dynamic DNS

The Router supports Dynamic DNS (Dynamic Domain Name Service). The Dynamic DNS

service allows a dynamic public IP address to be associated with a static host name in any of

the many domains, allowing access to a specified host from various locations on the Internet.

This is enabled to allow remote access to a host by clicking a hyperlinked URL in the form

hostname.dyndns.org

, Many ISPs assign public IP addresses using DHCP, and this can

make it difficult to locate a specific host on the LAN using standard DNS. If for example you are

running a public web server or VPN server on your LAN, this ensures that the host can be

located from the Internet if the public IP address changes. DDNS requires that an account be

setup with one of the supported DDNS providers.

Click

Add

to see the Add DDNS Settings section.

Enter the required DDNS information, click the

Apply / Save

button to save the information.

39

Note

DDNS requires that an account be setup with one of the

supported DDNS servers prior to engaging it on the Router.

This function will not work without an accepted account with a

DDNS server.

40

DSL

The DSL window enables you to configure the DSL settings of the gateway.

Select

DSL

from the

Advanced Setup

menu to open the DSL Settings window

If you clicked

Advanced Settings

in the

DSL Settings

window, the DSL Advanced Settings

window opens