19216811.live95
10 SUPPORT
DMS-CTC-20110713-0024 v1.0
10.4 Wireless Connection Troubleshooting
No Wireless Connectivity
Try the following:
Make sure that the wireless client adapter is enabled (message like “radio on”).
Make sure that the wireless client is configured for the correct wireless settings (Network Name, security settings).
If the signal is low or not available, try to reposition the MediaAccess Gateway or (if available) redirect the antenna(s) of
the MediaAccess Gateway for optimal performance.
Change the wireless channel
.
Poor Wireless Connectivity or Range
Try the following:
Check the signal strength, indicated by the wireless client manager. If the signal is low, try to reposition the MediaAccess
Gateway or (if available) redirect the antenna(s) of the MediaAccess Gateway for optimal performance.
Change the wireless channel
.
Use WPA(2)-PSK as encryption.
For more information, see
“5.4 Securing Your Wireless Connection” on page 44
.
Change the wireless channel
Proceed as follows:
1
Browse to the
MediaAccess Gateway GUI
.
For more information, see
“Accessing the MediaAccess Gateway GUI” on page 33
.
2
Under
Home Network
, click
Wireless
3
The
Wireless Access Point
page appears.
4
In the
Navigation bar
, click
Configure
.
5
Under
Configuration
, select the channel of your choice in the
Channel Selection
list.
6
Click
Apply
.
Can not connect via WPS
If you are having trouble connecting your wireless client via WPS, try to configure it manually. For more information, see
“5.2 Connecting Your Wireless Client without WPS” on page 42
.