Page 21 / 90
Scroll up to view Page 16 - 20
- 20 -
After setting, click
Next
, the page as shown in the following figure appears.
The following table describes the parameters in this page:
Field
Description
Obtain an IP address
automatically
Select it, the DHCP assigns the IP address for
PPPoE connection.
Use the following IP
address
Select it, you need to enter the IP address for
PPPoE connection, which is provided by your
ISP.
Enable NAT
Select the checkbox to enable network address
translation (NAT). If you do not select it and you
want to access the Internet normally, you must
add a route on the uplink equipment. Otherwise,
the access to the Internet fails. Normally, it is
required to enable NAT.
Page 22 / 90
- 21 -
After setting, click
Next
, the page as shown in the following figure appears.
The following table describes the parameters in this page:
Field
Description
PPP Username
Enter the username for PPPoE dial-up, which is
provided by your ISP.
PPP Password
Enter the password for PPPoE dial-up, which is
provided by your ISP.
PPP Connection
Type
You can select
Continuous
,
Connect on
Demand
, or
Manual
.
°
Continuous:
After dial-up is successful,
PPPoE connection is always on-line, no matter
whether the data is being transmitted or not.
It is recommended to select it.
°
Connect on Demand:
After dial-up is
successful, within the preset idle time, no data is
being transmitted, the router automatically
disconnects the PPPoE connection.
In this case, you need to enter the idle time.
°
Manual:
Select it, you need to dial up and
disconnect the connection mannually.
Page 23 / 90
- 22 -
Note:
If the WAN connection type is set to
PPPoA
, the parameters of the WAN
connection type are the same as that of
PPPoE
. For the parameters in these
pages, refer to the parameter description of
PPPoE
.
1483 MER/1483 Routed
In the
Connection Type
page, set the WAN connection type to
1483 MER
, the
encapsulation mode to
LLC/SNAP
.
After setting, click
Next
, the page as shown in the following figure appears.
Page 24 / 90
- 23 -
The following table describes the parameters in this page:
Field
Description
Obtain an IP address
automatically
Select it, DHCP automatically assigns the IP
address for WAN connection.
Use the following IP
address
Select it, you need to manually enter the IP
address, subnet mask, and default gateway
for WAN connection, which are provided by
your ISP.
Obtain DNS server
addresses automatically
Select it, DHCP automatically assigns DNS
server address.
Use the following DNS
server addresses
Select it, you need to manually enter the
primary DNS server address and secondary
DNS server address.
Enable NAT
Select it to enable network address
translation (NAT). If you do not select it and
you want to access the Internet normally,
Page 25 / 90
- 24 -
Field
Description
you must add a route on the uplink
equipment. Otherwise, the access to the
Internet fails. Normally, it is required to
enable NAT.
Note:
If the WAN connection type is set to
1483 Routed
, the parameters of the WAN
connection type are the same as that of
1483 MER
. For the parameters in these
pages, refer to the parameter description of
1483 MER
.
1483 Bridged
In the
Connection Type
page, set the WAN connection type to
1483 Bridged
, the
encapsulation mode to
LLC/SNAP
.
After setting, click
Next
, the page as shown in the following figure appears.
19216811.live