Page 16 / 69
Scroll up to view Page 11 - 15
E
|
3
9 Bring up the WLR-5000
Connect the supplied power-adapter to the power inlet port and connect it to
a wall outlet. Switch the WLR-5000 on by flipping the switch on the back of
the device. The WLR-5000 automatically enters the self-test phase. During
self-test phase, the Power LED will be lit continuously to indicate that this
product is in normal operation.
10 Initial Setup WLR-5000
LOGIN procedure
1.
OPEN your browser (e.g. Internet Explorer).
2.
Type
in the address bar and press [Enter]
Page 17 / 69
E
|
3
3.
Type user name and password. The default username is admin, the
password can be found on the back label on the bottom of your router.
4.
Click
OK
.
5.
You will see the home page of the WLR-5000.
The System status section allows you to monitor the current status of your
router, the UP time, hardware information, serial number as well as firmware
version information is displayed here.
Page 18 / 69
E
|
3
LAN settings
The LAN tab gives you the opportunity to change the IP settings of the WLR-
5000.
Click
<Apply>
at the bottom of this screen to save any changes.
IP address
192.168.0.1. It is the router’s LAN IP address (Your LAN clients
default gateway IP address).
IP Subnet Mask
255.255.255.0 Specify a Subnet Mask for your LAN segment.
802.1d Spanning Tree
is Disabled by default. If the 802.1d Spanning Tree
function is enabled, this router will use the spanning tree protocol to prevent
network loops.
DHCP Server
Enabled by default. You can enable or disable the DHCP server.
When DHCP is disabled no ip-addresses are assigned to clients and you have to
use static ip-addresses. When DHCP server is enabled your computers will be
assigned an ip-address automatically until the lease time expires.
Lease Time
Forever. In the Lease Time setting you can specify the time period
that the DHCP lends an IP address to your LAN clients. The DHCP will change
your LAN client’s IP address when this time threshold period is reached.
Page 19 / 69
E
|
3
IP Address Pool
You can select a particular IP address range for your DHCP
server to issue IP addresses to your LAN Clients.
Note
:
default IP range is
192.168.0.100 ~ 192.168.0.200. If you want
your PC(s) to have a static/fixed IP address, then you’ll have to choose
an IP address outside this IP address Pool
Domain Name
You can specify a Domain Name for your LAN. Or just keep the
default (sitecomwlr5000).
Page 20 / 69
E
|
3
Device Status
View the Broadband router’s current configuration settings. Device Status
displays the configuration settings you’ve configured in the Wizard / Basic
Settings / Wireless Settings section.
19216811.live