Page 21 / 61 Scroll up to view Page 16 - 20
Configuration Wizard
Click Wizard to configure the modem. The Setup wizard will now be displayed; check that
the adsl line is connected and click
“Start Scan” to do an automatic detection of the ADSL
settings. If you want to configure the modem manually you can click “Skip Scan”.
Select your country from the Country list. Select your internet provider. Click Next.
Page 22 / 61
Depending on the chosen provider, you may need to enter your user name and password
or hostname in the following window. After you have entered the correct information,
click Next.
Click Finish to complete the configuration.
Page 23 / 61
Basic Settings
LAN Settings
This page is used to configure the LAN interface of your ADSL Router. You can set IP
address, subnet mask, and IGMP Snooping or modify the IPv6 address range .
DHCP Settings
Page 24 / 61
You can configure your network and the router to use the Dynamic Host Configuration
Protocol (DHCP). This page allows you to select the DHCP mode that this router will
support.
There are two different DHCP Modes: DHCP Server and DHCP Relay. When the router is
acting as DHCP server, please configure the router in the “DHCP Server” pag
e; while
acting as DHCP Relay, you can setup the
relay in the “DHCP Relay” page.
Page 25 / 61
WAN Settings
This page allows you to manually configure the ADSL/WAN settings. The settings on this
page require some knowledge concerning the WAN configuration. We advise less-
experienced users to configure the WAN settings using the Wizard.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
VPI
: The valid range for the VPI is 0 to 255. Enter the VPI assigned to you. This field
may already be configured.
VCI
: The valid range for the VCI is 32 to 65535. Enter the VCI assigned to you. This field

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top