Page 36 / 62 Scroll up to view Page 31 - 35
36
Control table
"Control table" is the table at the bottom of the "MAC Address Control"
page. Each row of this table indicates the MAC address and the expected
IP address mapping of a client. There are four columns in this table:
MAC Address
MAC address indicates a specific client.
IP Address
Expected IP address of the corresponding
client. Keep it empty if you don't care its IP
address.
C
When "
Connection control
" is checked,
check "
C
" will allow the corresponding client
to connect to this device.
In this page, we provide the following Combobox and button to help you to input the MAC address.
You can select a specific client in the
DHCP clients
Combobox, and then click on the
Copy to
button to copy the MAC address of the client you select to the ID selected in the
ID
Combobox.
Previous page and Next Page
To make this setup page simple and clear, we have divided the
Control table
into several pages. You can use these buttons to
navigate to different pages.
Page 37 / 62
37
4.6.5 Miscellaneous Items
Remote Administrator Host/Port
In general, only Intranet user can browse the built-in web pages to perform administration task. This
feature enables you to perform administration task from remote host. If this feature is enabled, only the
specified IP address can perform remote administration. If the specified IP address is 0.0.0.0, any host
can connect to this product to perform administration task. You can use subnet mask bits "/nn" notation
to specified a group of trusted IP addresses. For example, "10.1.2.0/24".
NOTE: When Remote Administration is enabled, the web server port will be shifted to 88. You can
change web server port to other port, too.
Administrator Time-out
The time of no activity to logout automatically. Set it to zero to disable this feature.
Discard PING from WAN side
When this feature is enabled, any host on the WAN cannot ping this product.
SPI Mode
When this feature is enabled, the router will record the packet information pass through the router like
IP address, port address, ACK, SEQ number and so on. And the router will check every incoming
packet to detect if this packet is valid.
DoS Attack Detection
When this feature is enabled, the router will detect and log the DoS attack comes from the Internet.
Page 38 / 62
38
Currently, the router can detect the following DoS attack: SYN Attack, WinNuke, Port Scan, Ping of
Death, Land Attack etc.
VPN PPTP/IPSec Pass-Through
Please enable this feature, if you need to establish a PPTP or IPSEC connection that will pass through
this device.
Page 39 / 62
39
4.7 Advanced Settings
Page 40 / 62
40
4.7.1 System Time
Get Date and Time by NTP Protocol
Selected if you want to Get Date and Time by NTP Protocol.
Time Server
Select a NTP time server to consult UTC time
Time Zone
Select a time zone where this device locates.
Set Date and Time manually
Selected if you want to Set Date and Time manually.
Function of Buttons
Sync Now:
Synchronize system time with network time server

Rate

4.5 / 5 based on 2 votes.

Popular Repotec Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top