PROLiNK Hurricane 5200C/5201

ADSL2+ Modem / Router

User Manual

Page 46 of 59

for non-applicable.

Fields settings on the second block:

Field

Description

Outbound Priority

The priority level for the traffic that matches this classification rule. The

possible selections are (in descending priority): p0, p1, p2, p3.

IP Precedence

Select this field to mark the IP precedence bits in the packet that match this

classification rule.

IP Type of Service

Select this field to mark the IP TOS bits in the packet that match this

classification rule.

802.1p

Select this field to mark the 3-bit user-priority field in the 802.1p header of

the packet that matches this classification rule. Note that this 802.1p marking

is workable on a given PVC channel only if the VLAN tag is enabled in this

PVC channel.

PROLiNK Hurricane 5200C/5201

ADSL2+ Modem / Router

User Manual

Page 47 of 59

9.6

REMOTE ACCESS

The Remote Access function can secure remote host access to your modem/router from

LAN and WAN interfaces.

Fields in this page:

Field

Description

LAN

Check the services on the LAN column to allow access from LAN and

vice-versa.

WAN

Check the services on the WAN column to allow access from WAN and

vice-versa.

WAN Port

This field allows user to specify the port of the corresponding service. For

example, when HTTP service is changed to port 82, the HTTP server address

for WAN access is

http://dsl_addr:82

, where the

dsl_addr

is the WAN IP

address of modem/router.

PROLiNK Hurricane 5200C/5201

ADSL2+ Modem / Router

User Manual

Page 48 of 59

9.7

DNS CONFIGURATION

This page is used to select the way to obtain IP addresses of the DNS (Domain Name

Servers).

PROLiNK Hurricane 5200C/5201

ADSL2+ Modem / Router

User Manual

Page 49 of 59

Function buttons in this page:

Apply Changes

Set new DNS configuration. New parameters will take effect after the setting is saved into

flash memory and the system is rebooted

(see section “Admin” for save details)

.

Reset Selected

Discard your changes.

Field

Description

Attain DNS

Automatically

Select this item if you want to use the DNS servers obtained by the WAN

interface via the auto-configuration mechanism.

Set DNS Manually

Select this item to configure up to three DNS IP addresses.

PROLiNK Hurricane 5200C/5201

ADSL2+ Modem / Router

User Manual

Page 50 of 59

9.8

Dynamic DNS

Each time the modem/router connects to Internet, your ISP assigns a different IP address

to the modem. In order to remote access your modem from the Internet, you need to

manually track the WAN IP that is currently used. The Dynamic DNS feature allows you to

register your modem/router with a DNS server so that you can access your modem/router

remotely, each time using the same host name. The

Dynamic DNS

page allows you to

enable/disable the

Dynamic DNS feature.

On the

Dynamic DNS

page, configure the following fields:

Field

Description

Enable

Check this item to enable the DNS server registration account for the

modem/router.

DDNS provider

There are two options of DDNS providers: DynDNS and TZO. Changes may

occur depends on the services that you select.

Hostname

The Domain name that you registered with the DDNS server.

Username

User-name assigned by the DDNS service provider.

Password

Password assigned by the DDNS service provider.