19216811.liveDISCUS™ DRG A124G
TABLE 3
List of parameters on PPPoA ATM Interface
PARAMETER
DESCRIPTION
IP assigned by ISP
Select Yes if you have a dynamic IP address. Select No if you have a
static IP address
IP address
Enter the IP address provided by your ISP. For dynamic IP leave this
field blank
Connection type
It sets the connection mode to Always connected, Auto triggering by
traffic or Manual connection. For flat rate services use Always con-
nected
Idle time
Enter the maximum idle time for the Internet connection. After this time
has been exceeded the connection will be terminated. This setting only
applies when Connect type id set to Auto-triggering by traffic
Authentication pro-
tocol
Select the protocol from the drop down menu
Connection retry
timer
This is the timer controls the period between two PPP connection es-
tablishing retries. Connection retry timer only work when PPP link is in
disconnected status
Keep alive timer
PPP has its own protocol (LCP echo) to check the PPP connection
status periodically, keep alive timer controls the period between two
checks. Keep alive timer control work when PPP link is in connected
status
Username
Enter user name
Password
Enter password
Confirm Password
Confirm password
MTU
Leave the Maximum Transmission Unit (MTU) at the default value
unless instructed by your ISP
WAN >> ATM INTERFACE
1483 ROUTING
When
1483 Routing
is selected on ATM Interface, a list of parameters is to be
filled (see
Figure 5). Refer to
Table 4 to get information on parameter meaning
and values. When all fields have been properly filled, do select the
SAVE SET-
TINGS
button.