Page 206 / 234
Scroll up to view Page 201 - 205
USER MANUAL
Peplink Balance Series
-206 / 234 -
Copyright © 2014 Peplink
26.7.3 Daily
This page shows the daily bandwidth usage for all WAN connections, with the option of viewing each
individual connection.
Select the connection to check from the drop down menu. If you have enabled the
Bandwidth
Monitoring
feature as shown in section 12.4, the
Current Billing Cycle
table for that WAN connection
will be displayed.
Click on a date to view the client bandwidth usage of that specific date. This feature is not available if you
have selected to view the bandwidth usage of only a particular WAN connection.
The Scale of the graph can be set to show in
Megabyte (MB)
or
Gigabyte (GB)
.
Status
Page 207 / 234
USER MANUAL
Peplink Balance Series
-207 / 234 -
Copyright © 2014 Peplink
Click on a specific date to receive a breakdown of all client usage for that date.
Page 208 / 234
USER MANUAL
Peplink Balance Series
-208 / 234 -
Copyright © 2014 Peplink
26.7.4 Monthly
This page shows the monthly bandwidth usage for each WAN connection.
If you have enabled
Bandwidth Monitoring
feature as shown in section12.4, you can check the usage of
each particular connection and view the information by
Billing Cycle
or by
Calendar Month
.
Click the first two rows to view the client bandwidth usage on the last two months. This feature is not
available if you have chosen to view the bandwidth of an individual WAN connection.
The Scale of the graph can be set to show in
Megabyte (MB)
or
Gigabyte(GB)
.
Click on a specific month to receive a breakdown of all client usage for that month.
Page 209 / 234
USER MANUAL
Peplink Balance Series
-209 / 234 -
Copyright © 2014 Peplink
Appendix A. Restoration of Factory Defaults
To restore the factory default settings on a Peplink Balance unit, perform the following:
For Balance 20/30/30 LTE/50/210/310:
1.
Locate the reset button on the Peplink Balance unit.
2.
With a paper clip, press and keep the reset button pressed for at least 10 seconds, until the unit
reboots itself.
For Balance 305/380/580/710/1350/2500/MediaFast 200 and 500:
Use the buttons on front panel to control the LCD menu to go to
Maintenance
>
Factory Defaults
,
and then choose
Yes
to confirm.
Afterwards, the factory default settings will be restored.
Important Note
All user settings will be lost after restoring the factory default settings.
Regular backup of configuration parameters is strongly recommended.
Page 210 / 234
USER MANUAL
Peplink Balance Series
-210 / 234 -
Copyright © 2014 Peplink
Appendix B. Routing under DHCP, Static IP, and PPPoE
The information in this appendix applies only to situations where the Peplink Balance operates a WAN
connection under DHCP, Static IP, and PPPoE.
B.1
Routing via Network Address Translation (NAT)
When the Peplink Balance is operating under NAT mode, the source IP addresses of outgoing IP packets
are translated to the WAN IP address of Peplink Balance. With NAT, all LAN devices share the same
WAN IP address to access the Internet (i.e. the WAN IP address of Peplink Balance).
Operating the Peplink Balance in NAT mode requires only one WAN (Internet) IP address. In addition,
operating in NAT mode also has security advantages because LAN devices are hidden behind the
Peplink Balance. They are not directly accessible from the Internet, and, hence, less vulnerable to attacks.
The following figure shows the packet flow in NAT mode:
19216811.live