1. Home
    2. /
  2. Manuals
    3. /
  3. NETGEAR
    4. /
  4. DGND3300v2
    5. /
  5. 30
Page 146 / 177 Scroll up to view Page 141 - 145
146
|
Appendix A.
Troubleshooting
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
•
Is your wireless signal obstructed by objects between the router and your computer? See
Wireless Placement and Range Guidelines
on page
16.
If your wireless network appears and has good signal strength:
•
Is your N300 wireless modem router using the same channel as other nearby wireless
networks? If this is the case, there might be interference from other wireless networks.
You can change the channel in the Wireless Settings screen. See
Manually Configuring
Your Wireless Settings
on page
18.
•
Test another wireless device to see if the problem is limited to a specific computer.
•
You can also disable the modem router’s wireless security while testing to help isolate the
problem.
Downloaded from
www.Manualslib.com
manuals search engine
Page 147 / 177
Appendix B.
Default Configuration and Technical Specifications
|
147
B
B.
Default Configuration and Technical
Specifications
This appendix provides factory default settings and technical specifications for the N300
Wireless Dual Band ADSL2+ Modem Router DGND3300v2.
Restoring the Factory Configuration Settings
Note:
This procedure erases your current configuration, including your
wireless security. When you log in after resetting, you will be
prompted to configure these settings.
This section explains how to restore the factory default configuration settings. This procedure
restores the admin user name, the password to
password,
and the IP address to
192.168.0.1
or
. You can erase the current configuration and
restore factory defaults in two ways:
•
Use the Erase function of the router (see
Erasing the Configuration
on page
58).
•
Use the Restore Factory Settings button on the rear panel of the router. Use this method
for cases when the administration password or IP address is not known.
Using the Restore Factory Settings Button
To restore the factory configuration settings when you do not know the administration
password or IP address, you must use the Restore Factory Settings button on the rear panel
of the N300 wireless modem router.
1.
Press and hold the
Restore Factory Settings
button until the Power LED turns red
(about 6 seconds).
Downloaded from
www.Manualslib.com
manuals search engine
Page 148 / 177
148
|
Appendix B.
Default Configuration and Technical Specifications
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
2.
Release the Restore Factory Settings button and wait for the router to reboot.The Power
LED blinks red three times and then turns green when the default configuration settings
have been restored.
Feature
Default Setting
Router login
N300 Wireless Modem Router login
URL
or
http://www
.
routerlogin.com
User name (case-sensitive)
admin
Password (case-sensitive)
password
USB access
\\readyshare
Internet connection
WAN MAC address
Use default address
WAN MTU size
1458 for Annex A World except NA, 1492 for Annex A NA
and Annex B
ADSL line rate
automatically negotiated
Local network (LAN)
LAN IP
192.168.0.1
Subnet mask
255.255.255.0
RIP direction
None
RIP version
Disabled
RIP authentication
None
DHCP server
Enabled
DHCP starting IP address
192.168.0.2
DHCP ending IP address
192.168.0.254
DMZ
Disabled
Time zone
GMT for Annex A except NA; PST for NA; GMT + 1 H for
Annex B.
Time zone adjusted for daylight saving
time
Disabled
SNMP
Disabled
Downloaded from
www.Manualslib.com
manuals search engine
Page 149 / 177
Appendix B.
Default Configuration and Technical Specifications
|
149
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
Firewall
Inbound (communications coming in
from the Internet)
Disabled (except traffic on port 80, the HTTP port)
Outbound (communications going out
to the Internet)
Enabled (all)
Source MAC filtering
Disabled
Wireless
Wireless communication
Enabled
Name (11N SSID)
NETGEAR-Dual Band-N
Name (11G SSID)
NETGEAR-2.4G
Security
Disabled
Broadcast SSID
Enabled
Country/Region
United States in North America, otherwise varies by
region. For Annex B, Germany is default region.
11N Channel
Auto (available in Up to 300 Mbps at 2.4 GHz but not
available in Up to 300 Mbps at 5 GHz).
Maximum wireless signal rate derived from IEEE Standard
802.11 specifications. Actual throughput will vary. Network
conditions and environmental factors, including volume of
network traffic, building materials and construction, and
network overhead lower actual data throughput rate.
11G Channel
Auto
Maximum wireless signal rate derived from IEEE Standard
802.11 specifications. Actual throughput will vary. Network
conditions and environmental factors, including volume of
network traffic, building materials and construction, and
network overhead lower actual data throughput rate.
Operating Mode
Up to 300Mbps at 5GHz and 54Mbps at 2.4GHz
Output Power
Full
Feature
Default Setting
Downloaded from
www.Manualslib.com
manuals search engine
Page 150 / 177
150
|
Appendix B.
Default Configuration and Technical Specifications
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
Technical Specifications
Feature
General
Network Protocol and Standards Compatibility
Data and Routing Protocols
TCP/IP, RIP-1, RIP-2, DHCP, PPPoE or PPPoA, RFC 1483 Bridged or
Routed Ethernet, and RFC 1577 Classical IP over ATM
Power Adapter
North America
120V, 60 Hz, input
UK, Australia
240V, 50 Hz, input
Europe
230V, 50 Hz, input
All regions (output)
12V @ 1.5A output
Physical
Dimensions
8.9 in. x 6.8 in. x 1.5 in. (225.5 mm x 172 mm x 39 mm)
Weight
1.2 lbs. (0.54 kg)
Environmental
Operating temperature
0° to 40° C
(32º to 104º F)
Operating humidity
10% to 90% relative humidity, noncondensing
Storage temperature
–20° to 70° C
(–4º to 158º F)
Regulatory Compliance
Meets requirements of
FCC Part 15 Class B; VCCI Class B; EN 55 022 (CISPR 22), Class B
Interface Specifications
LAN
10BASE-T or 100BASE-Tx, RJ-45
WAN (ADSL)
ITU 992.1 (G.dmt) Annex A, ITU 992.2 (G.lite), ITU 992.3 ADSL2
(G.dmt.bis), ITU 992.5 ADSL2+. Annex A ADSL is supported by
DGND3300v2, Annex B ADSL is supported by DGND3300v2.
USB
File systems
FAT, FAT32, and NTFS (read only)
Downloaded from
www.Manualslib.com
manuals search engine

Rate

3.5 / 5 based on 2 votes.

Popular NETGEAR Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top