NETGEAR DG834G Router Manual PDF (Setup & Configuration Guide)

Home

Manuals

NETGEAR

DG834G

Page 211 / 268 Scroll up to view Page 206 - 210

Reference Manual for the Model Wireless ADSL Firewall Router DG834G

Wireless Networking Basics

D-7

WEP Configuration Options

The WEP settings must match on all 802.11 devices that are within the same wireless network as

identified by the SSID. In general, if your mobile clients will roam between access points, then all

of the 802.11 access points and all of the 802.11 client adapters on the network must have the same

WEP settings.

Note:

Whatever keys you enter for an AP, you must also enter the same keys for the client adapter

in the same order. In other words, WEP key 1 on the AP must match WEP key 1 on the client

adapter, WEP key 2 on the AP must match WEP key 2 on the client adapter, and so on.

Note:

The AP and the client adapters can have different default WEP Keys as long as the keys are

in the same order. In other words, the AP can use WEP key 2 as its default key to transmit while a

client adapter can use WEP key 3 as its default key to transmit. The two devices will communicate

as long as the AP’s WEP key 2 is the same as the client’s WEP key 2 and the AP’s WEP key 3 is

the same as the client’s WEP key 3.

Wireless Channels

The wireless frequencies used by 802.11b/g networks are discussed below.

IEEE 802.11b/g wireless nodes communicate with each other using radio frequency signals in the

ISM (Industrial, Scientific, and Medical) band between 2.4 GHz and 2.5 GHz. Neighboring

channels are 5 MHz apart. However, due to spread spectrum effect of the signals, a node sending

signals using a particular channel will utilize frequency spectrum 12.5 MHz above and below the

center channel frequency. As a result, two separate wireless networks using neighboring channels

(for example, channel 1 and channel 2) in the same general vicinity will interfere with each other.

Applying two channels that allow the maximum channel separation will decrease the amount of

channel cross-talk, and provide a noticeable performance increase over networks with minimal

channel separation.

The radio frequency channels used in 802.11b/g networks are listed in

Table D-2

Page 212 / 268

Reference Manual for the Model Wireless ADSL Firewall Router DG834G

D-8

Wireless Networking Basics

Note:

The available channels supported by the wireless products in various countries are different.

For example, Channels 1 to 11 are supported in the U.S. and Canada, and Channels 1 to 13 are

supported in Europe and Australia.

The preferred channel separation between the channels in neighboring wireless networks is 25

MHz (5 channels). This means that you can apply up to three different channels within your

wireless network. There are only 11 usable wireless channels in the United States. It is

recommended that you start using channel 1 and grow to use channel 6, and 11 when necessary, as

these three channels do not overlap.

WPA Wireless Security

Wi-Fi Protected Access (WPA) is a specification of standards-based, interoperable security

enhancements that increase the level of data protection and access control for existing and future

wireless LAN systems.

Table D-2:

802.11b/g Radio Frequency Channels

Channel

Center Frequency

Frequency Spread

2412 MHz

2399.5 MHz - 2424.5 MHz

2417 MHz

2404.5 MHz - 2429.5 MHz

2422 MHz

2409.5 MHz - 2434.5 MHz

2427 MHz

2414.5 MHz - 2439.5 MHz

2432 MHz

2419.5 MHz - 2444.5 MHz

2437 MHz

2424.5 MHz - 2449.5 MHz

2442 MHz

2429.5 MHz - 2454.5 MHz

2447 MHz

2434.5 MHz - 2459.5 MHz

2452 MHz

2439.5 MHz - 2464.5 MHz

2457 MHz

2444.5 MHz - 2469.5 MHz

2462 MHz

2449.5 MHz - 2474.5 MHz

2467 MHz

2454.5 MHz - 2479.5 MHz

2472 MHz

2459.5 MHz - 2484.5 MHz

Page 213 / 268

Reference Manual for the Model Wireless ADSL Firewall Router DG834G

Wireless Networking Basics

D-9

The IEEE introduced the WEP as an optional security measure to secure 802.11b (Wi-Fi) WLANs,

but inherent weaknesses in the standard soon became obvious. In response to this situation, the

Wi-Fi Alliance announced a new security architecture in October 2002 that remedies the

shortcomings of WEP. This standard, formerly known as Safe Secure Network (SSN), is designed

to work with existing 802.11 products and offers forward compatibility with 802.11i, the new

wireless security architecture being defined in the IEEE.

WPA offers the following benefits:

•

Enhanced data privacy

•

Robust key management

•

Data origin authentication

•

Data integrity protection

The Wi-Fi Alliance is now performing interoperability certification testing on Wi-Fi Protected

Access products. Starting August of 2003, all new Wi-Fi certified products will have to support

WPA. NETGEAR will implement WPA on client and access point products and make this

available in the second half of 2003. Existing Wi-Fi certified products will have one year to add

WPA support or they will lose their Wi-Fi certification.

The 802.11i standard is currently in draft form, with ratification due at the end of 2003. While the

new IEEE 802.11i standard is being ratified, wireless vendors have agreed on WPA as an

interoperable interim standard.

How Does WPA Compare to WEP?

WEP is a data encryption method and is not intended as a user authentication mechanism. WPA

user authentication is implemented using 802.1x and the Extensible Authentication Protocol

(EAP). Support for 802.1x authentication is required in WPA. In the 802.11 standard, 802.1x

authentication was optional. For details on EAP specifically, refer to IETF's RFC 2284.

With 802.11 WEP, all access points and client wireless adapters on a particular wireless LAN must

use the same encryption key. A major problem with the 802.11 standard is that the keys are

cumbersome to change. If you do not update the WEP keys often, an unauthorized person with a

sniffing tool can monitor your network for less than a day and decode the encrypted messages.

Products based on the 802.11 standard alone offer system administrators no effective method to

update the keys.

Page 214 / 268

Reference Manual for the Model Wireless ADSL Firewall Router DG834G

D-10

Wireless Networking Basics

For 802.11, WEP encryption is optional. For WPA, encryption using Temporal Key Integrity

Protocol (TKIP) is required. TKIP replaces WEP with a new encryption algorithm that is stronger

than the WEP algorithm, but that uses the calculation facilities present on existing wireless devices

to perform encryption operations. TKIP provides important data encryption enhancements

including a per-packet key mixing function, a message integrity check (MIC) named Michael, an

extended initialization vector (IV) with sequencing rules, and a re-keying mechanism. Through

these enhancements, TKIP addresses all of known WEP vulnerabilities.

How Does WPA Compare to IEEE 802.11i?

WPA will be forward compatible with the IEEE 802.11i security specification currently under

development. WPA is a subset of the current 802.11i draft and uses certain pieces of the 802.11i

draft that are ready to bring to market today, such as 802.1x and TKIP. The main pieces of the

802.11i draft that are not included in WPA are secure IBSS (Ad-Hoc mode), secure fast handoff

(for specialized 802.11 VoIP phones), as well as enhanced encryption protocols, such as

AES-CCMP. These features are either not yet ready for market or will require hardware upgrades

to implement.

What are the Key Features of WPA Security?

The following security features are included in the WPA standard:

•

WPA Authentication

•

WPA Encryption Key Management

–

Temporal Key Integrity Protocol (TKIP)

–

Michael message integrity code (MIC)

–

AES Support (to be phased in)

•

Support for a Mixture of WPA and WEP Wireless Clients, but mixing WEP and WPA is

discouraged

These features are discussed below.

WPA addresses most of the known WEP vulnerabilities and is primarily intended for wireless

infrastructure networks as found in the enterprise. This infrastructure includes stations, access

points, and authentication servers (typically RADIUS servers). The RADIUS server holds (or has

access to) user credentials (for example, user names and passwords) and authenticates wireless

users before they gain access to the network.

Page 215 / 268

Reference Manual for the Model Wireless ADSL Firewall Router DG834G

Wireless Networking Basics

D-11

The strength of WPA comes from an integrated sequence of operations that encompass 802.1X/

EAP authentication and sophisticated key management and encryption techniques. Its major

operations include:

•

Network security capability determination. This occurs at the 802.11 level and is

communicated through WPA information elements in Beacon, Probe Response, and (Re)

Association Requests. Information in these elements includes the authentication method

(802.1X or Pre-shared key) and the preferred cipher suite (WEP, TKIP, or AES).

The primary information conveyed in the Beacon frames is the authentication method and the

cipher suite. Possible authentication methods include 802.1X and Pre-shared key. Pre-shared

key is an authentication method that uses a statically configured pass phrase on both the

stations and the access point. This obviates the need for an authentication server, which in

many home and small office environments will not be available nor desirable. Possible cipher

suites include: WEP, TKIP, and AES (Advanced Encryption Standard). We talk more about

TKIP and AES when addressing data privacy below.

•

Authentication. EAP over 802.1X is used for authentication. Mutual authentication is gained

by choosing an EAP type supporting this feature and is required by WPA. 802.1X port access

control prevents full access to the network until authentication completes. 802.1X

EAPOL-Key packets are used by WPA to distribute per-session keys to those stations

successfully authenticated.

The supplicant in the station uses the authentication and cipher suite information contained in

the information elements to decide which authentication method and cipher suite to use. For

example, if the access point is using the pre-shared key method then the supplicant need not

authenticate using full-blown 802.1X. Rather, the supplicant must simply prove to the access

point that it is in possession of the pre-shared key. If the supplicant detects that the service set

does not contain a WPA information element then it knows it must use pre-WPA 802.1X

authentication and key management in order to access the network.

•

Key management. WPA features a robust key generation/management system that integrates

the authentication and data privacy functions. Keys are generated after successful

authentication and through a subsequent 4-way handshake between the station and Access

Point (AP).

•

Data Privacy (Encryption). Temporal Key Integrity Protocol (TKIP) is used to wrap WEP in

sophisticated cryptographic and security techniques to overcome most of its weaknesses.

•

Data integrity. TKIP includes a message integrity code (MIC) at the end of each plaintext

message to ensure messages are not being spoofed.

Rate

Popular NETGEAR Models

Famous Router IPs

Famous Router Companies

Bookmark Our Site

Share