1. Home
    2. /
  2. Manuals
    3. /
  3. NETGEAR
    4. /
  4. CG3700EMR-1CMNDS
    5. /
  5. 15
Page 71 / 77 Scroll up to view Page 66 - 70
71
A
A.
Supplemental Information
This appendix includes the following sections.
•
Factory Default Settings
•
Technical Specifications
Page 72 / 77
Supplemental Information
72
Wireless Cable Voice Gateway CG3700EMR-1CMNDS
Factory Default Settings
To return the gateway to its factory settings, press and hold the
Reset
button for over seven
seconds. The gateway resets and returns to the factory configuration settings shown in the
following table.
Table 3.
Factory default settings
Factory Default Settings
Gateway login
User login URL
User name and password
(case-sensitive)
admin / password
Local network
(LAN)
LAN IP
192.168.0.1
Subnet mask
255.255.255.0
DHCP server
Enabled
DHCP starting IP address
192.168.0.2
DHCP ending IP address
192.168.0.254
Firewall
Inbound communication from the
Internet
Disabled (except traffic on port 80, the HTTP port)
Outbound communication to the
Internet
Enabled (all)
Source MAC filtering
Disabled
Internet
connection
WAN MAC address
Use default hardware address
Wireless
Wireless communication
Enabled
SSID name
As shown on the product label
Security
WPA/WPA2.
The default WPA/WPA2 passphrase is on the
product label.
Broadcast SSID
Enabled
Page 73 / 77
Supplemental Information
73
Wireless Cable Voice Gateway CG3700EMR-1CMNDS
Technical Specifications
The following table describes the technical specifications for the gateway.
Table 4.
Technical specifications
Technical Specifications
Network protocol and
standards compatibility
Data and routing protocols: TCP/IP, DHCP server and client, DNS relay, NAT
(many-to-one)
Power adapter
•
Europe (input): 230V, 50 Hz, input
•
All regions (output): 12 V-DC @ 2.5A output
Physical specifications
•
Dimensions: 8.2 by 4.5 by 1.0 in. (208 by 113 by 26 mm)
•
Weight: 0.65 lb (0.28 kg)
Environmental
•
Operating temperature: 32° to 140°F (0° to 40°C)
•
Operating humidity: 90% maximum relative humidity, noncondensing
•
Electromagnetic emissions: Meets requirements of FCC Part 15 Class B.
Interface
Local: 10BASE-T, 100/1000BASE-Tx, RJ-45 802.11n/g/b
Internet: DOCSIS 3.0. Downward compatible with DOCSIS 2.0, 1.1 and 1.0
Wireless
(continued)
Transmission speed
Auto
*
Country/region
EU
RF channel
Auto
Operating mode
n, g, and b
Data rate
Best
Output power
Full
Access point
Enabled
Authentication type
Open System
Wireless card access list
All wireless stations allowed
*. Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will
vary. Network conditions and environmental factors, including volume of network traffic, building materials
and construction, and network overhead, may lower actual data throughput rate.
Table 3.
Factory default settings (continued)
Factory Default Settings
(continued)
Page 74 / 77
74
B
B.
Notification of Compliance
NETGEAR dual band - wireless
Regulatory Compliance Information
This section includes user requirements for operating this product in accordance with National laws for usage of radio
spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may
result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority.
This product's firmware limits operation to only the channels allowed in a particular Region or Country. Therefore, all
options described in this user's guide may not be available in your version of the product.
Europe – EU Declaration of Conformity
Products bearing the
marking comply with the following EU directives:
•
EMC Directive 2004/108/EC
•
Low Voltage Directive 2006/95/EC
If this product has telecommunications functionality, it also complies with the requirements of the following EU
Directive:
•
R&TTE Directive 1999/5/EC
Compliance with these directives implies conformity to harmonized European standards that are noted in the EU
Declaration of Conformity.
For indoor use only. Valid in all EU member states, EFTA states, and Switzerland.
This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may
be limited to 10 mW EIRP in the frequency range of 2454 - 2483.5 MHz. For detailed information the end-user should
contact the national spectrum authority in France.
FCC Requirements for Operation in the United States
FCC Information to User
This product does not contain any user serviceable components and is to be used with approved antennas only.
Any product changes or modifications will invalidate all applicable regulatory certifications and approvals.
FCC Guidelines for Human Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter except in accordance with FCC multi-transmitter product procedures.
FCC Declaration of Conformity
We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole responsibility that the
Product Name & Model complies with Part 15 Subpart B of FCC CFR47 Rules. Operation is subject to the following
two conditions:
•
This device may not cause harmful interference, and
•
This device must accept any interference received, including interference that may cause undesired operation.
Page 75 / 77
Notification of Compliance
75
Product Name & Model
FCC Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following methods:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
•
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
•
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
•
For product available in the USA and Canada market, only channel 1~11 can be operated. Selection of other
channels is not possible.
•
Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11 peuvent être exploités.
Sélection d'autres canaux n'est pas possible.
•
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter except in accordance with FCC multi-transmitter product procedures.
•
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre
antenne ou transmetteur.
•
For operation within a 5.15 ~ 5.25 GHz/5.47 ~ 5.725 GHz frequency range, it is restricted to an indoor
environment. The band from 5600-5650 MHz will be disabled by the software during the manufacturing and
cannot be changed by the end user. This device meets all the other requirements specified in Part 15E, Section
15.407 of the FCC Rules.
•
Devices will not permit operations on channels 120-132 for 11a and 11n/a which overlap the 5600 - 5650 MHz
band.
Canadian Department of Communications Radio Interference Regulations
This digital apparatus (Product Name & Model) does not exceed the Class B limits for radio-noise emissions from
digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.
CAN ICES-3 (B)/NMB-3(B)
Industry Canada
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence.
Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage
préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
The device could automatically discontinue transmission in case of absence of information to transmit, or operational
failure. Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive
codes where required by the technology.
Le dispositif pourrait automatiquement cesser d'émettre en cas d'absence d'informations à transmettre, ou une
défaillance opérationnelle. Notez que ce n'est pas l'intention d'interdire la transmission des informations de contrôle ou
de signalisation ou l'utilisation de codes répétitifs lorsque requis par la technologie.

Rate

4 / 5 based on 1 vote.

Popular NETGEAR Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top