Page 51 / 60
Scroll up to view Page 46 - 50
YML901 Rev1
NB7 Series User Guide
NB7 Series User Guide
www.netcomm.com.au
³1
NB7 Series
Management > Access Control
This feature enables you manage the user access rights for remote access management based on the Services
being used, IP addresses and Passwords.
Management > Access Control > Services
Select which Services to allow and whether to allow from the LAN or the WAN.
Management > Access Control > IP Addresses
The Access Control Mode is disabled by default.
To allow remote management based on an authorized IP address, select Enable and click Add.
Key in the IP address of the PC from which a user will be allowed to access the web configuration menu.
Click Save/Apply to take effect the settings. Then the IP Address will be added into the table list.
To delete the existing IP address, tick the Remove checkbox next to the selected IP address in the table list and
click then Remove.
Page 52 / 60
NB7 Series User Guide
YML901 Rev1
³±
www.netcomm.com.au
Management > Access Control > Passwords
When you configure the router through an Internet browser, the system requires you to enter your user name and
password to validate your access permission. By default, the Username is set to “admin” and the Password to “admin”.
Page 53 / 60
YML901 Rev1
NB7 Series User Guide
NB7 Series User Guide
www.netcomm.com.au
³²
NB7 Series
Management > Update Software
The router’s software is stored in the FLASH memory and can be upgraded as new software is released. Click
Browse to locate the software file and then click Update Software.
Management > Save/Reboot
This feature allows the router to enable new network configuration to take effect or to clear problems with the
modem router’s network connection.
Safety Precautions
•
Do not open, service, or change any component.
•
Only qualified technical specialists are allowed to service the equipment.
•
Observe safety precautions to avoid electric shock
•
Check voltage before connecting to the power supply. Connecting to the wrong voltage will damage the
equipment.
Page 55 / 60
YML901 Rev1
NB7 Series User Guide
NB7 Series User Guide
www.netcomm.com.au
³³
NB7 Series
How to change the
security settings
WEP encryption
The NB7Plus4W has the WEP encryption enabled by default. To change the encryption key, please follow the
steps below:
1.
Connect the computer directly to the modem using an Ethernet cable.
2.
Open the web configuration,
http://192.168.1.1/ from your web browser i.e. Internet explorer, Firefox.
3.
At the log in screen, enter the Username and password. The default Username is “admin” and the default
Password is “admin”. Then click on “Login”.
4.
Click on “netcomm 7 series” and then click on “Security”
5.
Change the Encryption Strength to either 64 bit or 128 bit.
Notes:
128bit Cipher is more secure however it will lower the data transfer speed compare to 64bit. For most home users, 64bit Cipher is adequate.
Notes:
64 bit Cipher needs 10 digits Encryption key and 128 bit Cipher needs 26 digits Encryption key.
6.
Change the Network key 1 from “a1b2c3d4e5” to the new key.
Notes:
WEP Encryption key can only use numbers from 0 to 9 and letters from A to F. 64 bit Cipher needs 10 digits Encryption key and 128 bit
Cipher needs 26 digits Encryption key.
7.
Click on “Save/Apply”
Notes:
After changing the security settings, you need to remove the old wireless settings and reconfigure the wireless computer according to
the new settings.
19216811.live