Page 51 / 57 Scroll up to view Page 46 - 50
www.netcommwireless.com
51
NetComm NB604N
ADSL2+ Wireless N300 Modem
YML604X
IP Restriction
The IP restriction page enables you to set a list of IP Addresses able to access the Management Console.
To delete an IP restriction entry, click the Remove checkbox next to the IP restriction entry and click Remove.
Click Add to add a new IP restriction.
Enter the Start and End IP address range and click Apply to save the new IP Restriction configuration settings.
Page 52 / 57
NB604N
ADSL2+ Wireless N300 Modem Router
52
NetComm NB604N
ADSL2+ Wireless N300 Modem
YML604X
www.netcommwireless.com
Update Software
The router’s software is stored in the FLASH memory and can be upgraded as new software is released.
Click Browse to locate the software file and then click Update Software.
Reboot
This
feature allows the router to enable new network configuration to take effect or to clear problems with the modem router’s
network connection.
Page 53 / 57
www.netcommwireless.com
53
NetComm NB604N
ADSL2+ Wireless N300 Modem
YML604X
Technical Data
The following table lists the hardware specifications of the NB604N.
MODEL
NB604N
DDR SDRAM
64MB DDR2
Serial Flash
4 MB/8 MB/16 MB
Modem Chipset
BCM63281
ADSL Compliance
• G.992.1 (T1.413)
• G.992.2 (G.dmt), G.lite
• G.992.3 (G.bis/ADS L2)
• G.992.5 (ADSL2+)
• Annex L (reach extended ADSL2)
LED Indicators
Power, DSL, Internet, LAN1
LAN4, WLAN, WPS, USB
Operating Temperature
0 ~ 40 degrees Celsius (operating temperature)
Power input
12VDC
1.5A
Dimensions & Weight
181 mm (L) x 137 mm (H) x 34 mm (W)
250 grams
Regulatory Compliancy
A-Tick
Electrical Specifications
It is recommended that the NB604N be powered by the supplied 12VDC/1.5A power supply. A replacement power supply is
available from the NetComm Online shop.
Environmental Specifications / Tolerances
The NB604N housing enables it to operate over a wide variety of temperatures fro
m 0˚C ~
40
˚C.
Page 54 / 57
NB604N
ADSL2+ Wireless N300 Modem Router
54
NetComm NB604N
ADSL2+ Wireless N300 Modem
YML604X
www.netcommwireless.com
FAQ
1.
I cannot access the Management Console web page.
The default IP address of the unit is 192.168.1.1, so first try to open a web browser to this address. Also check that your
PC/Device
is on the same subnet as the router’s Ethernet port.
2.
The router was connected but cannot get back online.
Verify your DSL service is active and that the telephone line has been connected securely.
3.
I cannot connect wirelessly.
Verify the Wireless network function is enabled and that you are entering the correct Wireless Security key and are able to
see the Wireless network during an SSID scan.
4.
The router has a connection but cannot access the internet.
Verify your PC or device is on the same subnet as the Router and that DHCP is enabled.
5.
I cannot access any attached USB Storage.
Verify that you have created an appropriate user account and granted the required access permissions for the volume.
Page 55 / 57
www.netcommwireless.com
55
NetComm NB604N
ADSL2+ Wireless N300 Modem
YML604X
Legal & Regulatory Information
1.
Intellectual Property Rights
All intellectual property rights (including copyright and trade mark rights) subsisting in, relating to or arising out this Manual are
owned by and vest in NetComm Limited (ACN 002490486) (NetComm) (or its licensors). This Manual does not transfer any right,
title or interest in NetComm’s (or its licensors’
) intellectual property rights to you.
You are permitted to use this Manual for the sole purpose of using the NetComm product to which it relates. Otherwise no part of
this Manual may be reproduced, stored in a retrieval system or transmitted in any form, by any means, be it electronic, mechanical,
recording or otherwise, without the prior written permission of NetComm.
NetComm is a trademark of NetComm. All other trademarks are acknowledged to be the property of their respective owners.
2.
Customer Information
The Australian Communications & Media Authority (ACMA) requires you to be aware of the following information and warnings:
1.
This unit may be connected to the Telecommunication Network through a line cord which meets the requirements of the
AS/CA S008-2011 Standard.
2.
This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick as set by the ACMA.
These standards are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio noise and, if not installed and used in accordance with the instructions
detailed within this manual, may cause interference to radio communications. However, there is no guarantee that
interference will not occur with the installation of this product in your home or office. If this equipment does
cause some
degree of interference
to radio or television reception, which can be determined by turning the equipment off and on, we
encourage the user to try to correct the interference by one or more of the following measures:
Change the direction or relocate the receiving antenna.
Increase the separation between this equipment and the receiver.
Connect the equipment to an alternate power outlet on a different power circuit from that to which the receiver/TV is
connected.
Consult an experienced radio/TV technician for help.
3.
The power supply that is provided with this unit is only intended for use with this product. Do not use this power supply with
any other product or do not use any other power supply that is not approved for use with this product by NetComm. Failure
to do so may cause damage to this product, fire or result in personal injury.
3.
Consumer Protection Laws
Australian and New Zealand consumer law in certain circumstances implies mandatory guarantees, conditions and warranties which
cannot be excluded by NetComm and legislation of another country's Government may have a similar effect (together these are the
Consumer Protection Laws).
Any warranty or representation provided by NetComm is in addition to, and not in replacement of,
your rights under such Consumer Protection Laws.
If you purchased our goods in Australia and you are a consumer, you are entitled to a replacement or refund for a major failure and
for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced
if the goods fail to be of acceptable quality and the failure does not amount to a major failure. If you purchased our goods in New
Zealand and are a consumer you will also be entitled to similar statutory guarantees.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top